Feeder installation
A. Hanging Feeder
1. The feeder can be hanged from any type of vertical structure such as a hanging pole, tree limb
or wooden support frame. The structure must be able to hold approximately 5 lbs. and must be
easy to reach in order to make refilling the feeder easy.
2. The feeder features four hanging holes located at the top of the housing, under the lid. Attach
either wire or chain to hanging holes and hang feeder over waters edge. See Figure B.
3. Test feeder by pressing the "M" button on the timer and ensure that the feed drops into the water
and not onto the ground.
Figure B
WWW.CURRENT-USA.COM