Table of Contents
Advertisement
Feeder installation
Feeder Preperation:
A. Before Installation
1. Remove the Feeder from the box and inspect thoroughly for any signs of damage, even if the box
does not show damage. If you notice any damage (cracked covers, damaged timer, broken lid,
etc...) please stop and contact your dealer immediately.
2. Remove the lid and fill with koi food. The Koi Chef is designed to operate with pelleted koi food
a minimum of 1/16" in diameter. Replace lid and ensure lid locks tight.
3. Open timer cover and install two (2) C batteries (not included.) Follow programming instructions
listed on page 4.
The koi chef is designed to be installed two ways:
A. POST MOUNTING
1. Using mounting bracket included, screw bracket onto post flat side out. Ensure that the flat edge
faces down and notched edge faces up.
2. Slide feeder onto hanging bracket. Ensure that the bottom of the feeder is located above the
water as feed will drop down vertically from the feeder. See Figure A.
3. Test feeder by pressing the "M" button on the timer and ensure that the feed drops into the water
and not onto the ground.
Ensure feeder is over
waters edge
Figure A
WWW.CURRENT-USA.COM
Advertisement
Table of Contents
