Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Ryobi RADD-G
Summary of Contents for Ryobi RADD-G
- Page 1 RADD-G REVERSIBLE AIR DRILL OPERATOR'S MANUAL ORIGINAL INSTRUCTIONS...
- Page 2 Important! It is essential that you read the instructions in this manual before operating this machine. Subject to technical modifications.
- Page 3 DESCRIPTION 1. Chuck 4. Air inlet 2. Trigger 5. Nitto style coupler 3. Reverse valve 6. Drill bit (not included) Fig.1 Fig.2 Fig.3 Fig.4 Fig.5 Fig.6 Quick Quick connector connector Lubricator Filter Tool compressor Cut-off valve Quick Quick coupler coupler Regulator Air hose (0-8.5 bar)
-
Page 4: General Safety Rules
case tools and pistol-grip tools. In any case, it is GENERAL SAFETY RULES recommended to use a means to absorb the reaction torque above 4 Nm for straight tools and above 10 Nm ■ For multiple hazards, read and understand the safety for pistol-grip tools. -
Page 5: Dust And Fume Hazards
DUST AND FUME HAZARDS exposure. If the vibration emission value obtained using ISO 28927-5 for drills or ISO 20643 for tappers does ■ Dust and fumes generated when using drills and not adequately represent the vibration emission in the tappers can cause ill health (for example, cancer, birth intended uses (and foreseeable misuses) of the machine, defects, asthma and/or dermatitis);... -
Page 6: Specifications
SYMBOLS APPLICATION The product is designed for drilling, tapping, honing and hole sawing. The features of the product include: Safety alert reversible and keyless air drill, durable lightweight composite housing, variable speed trigger, exhaust, and a quick coupler. Any other use is forbidden. –... -
Page 7: Loading And Operation
■ Keep hose away from heat, oil and sharp edges. Check LUBRICATION hose for wear, and make sure that all connections are secure. automatic in-line filter-regulator-lubricator recommended (Fig. 7) as it increases product life and ■ Air tools should not be used in a potentially explosive keeps the product in sustained operation. - Page 8 repair or adjustment. When replacing O-rings or cylinder, PROBLEM: Product will not shut off. lubricate with air tool oil before assembly. POSSIBLE CAUSE PROBLEM: Product runs at normal speed but fails ‘O’ rings throttle valve is dislodged from seat inlet under load.
-
Page 9: Parts List
PARTS LIST Description Description Description Description Housing Bushing Cylinder cap Gear shaft Roll pin 3 x 23 Reverse lever Cylinder Bearing 6201Z Exhaust deflector O-ring 11.5 x 1.8 Rotor blade Clamp nut Air inlet plug Spring Rotor Steel wire Anti-dust cap Trigger Washer Washer... - Page 10 Techtronic Industries (Australia) Pty. Ltd. Level 1, 660 Doncaster Road Doncaster, VIC 3108, Australia Techtronic Industries New Zealand Ltd. 18-26 Amelia Earhart Avenue Mangere, Auckland 2022, New Zealand...