Wiring Diagram - Sanyo EM-FL50N Service Manual

4. Remove the 2 screws securing the turntable
motor. Withdraw the motor and disconnect
the 2 lead wires from the motor.
5. Reverse the above procedure to reinstall
new parts., note the following:
6. Replace the turntable motor access cover
by engaging the long tab into the slot pro-
vided on the bottom plate and secure the
other end with an M4 self tapping screw.
DOOR ASSEMBLY REMOVAL
1. Disconnect power from the unit, remove
the cabinet and discharge the capacitor.
2. Open the door and carefully remove the
choke cover. Remove door.
3. Reverse the above procedure to install the
new door assembly.
4. The microwave sealing strips located on
the door must not be removed or damaged.
IMPORTANT: AFTER THE DOOR HAS
BEEN REPLACED, THE INTERLOCKS MUST
BE ADJUSTED PROPERLY. SEE INTERLOCK
ADJUSTMENTS SECTION BEFORE OPER-
ATING THE OVEN.
NOTE: AFTER REPAIRS HAVE BEEN
MADE, IT IS VERY IMPORTANT TO MAKE A
MICROWAVE LEAKAGE CHECK OF THE
DOOR. SEE THE MICROWAVE RADIATION
TEST SECTION IN THIS MANUAL.
CONTROL
REMOVAL AND REPLACEMENT
1. Unplug the power cord. remove the cabinet
and discharge the capacitor. Open the
door.
2. Remove screw securing control panel to
front of oven chassis.
3. Remove
depressing the four plastic retaining tabs.
4. To reassemble, reverse the above process.
Be sure to reinstall the green ground wire
under the screw.
ELECTRONIC CONTROLLER ASSEM-
BLY REMOVAL
1. Disconnect power from the unit. Remove
the cabinet and discharge the capacitor.
CHOKE
COVER
2. Remove screw at top that holds the control
panel to the oven chassis.
DOOR
3. Controller can be replaced by removing
screws through rear of control panel and
replacing with new control, wire for wire.
Reverse above steps to reinstall.
4. NOTE: The only replaceable parts on the
controller are the complete PCB assembly
and the keyboard assembly. No other parts
are available.
PLASTIC
5. When replacing a keyboard assembly, be
HINGE
sure to attach it to the PCB panel.
WASHER
THERMAL PROTECTOR REMOVAL
1. Unplug the power cord, remove the outer
cabinet and discharge the capacitor.
2. Disconnect the connectors from the ther-
PANEL ASSEMBLY
door release assembly by
8
mal protector terminals.
3. Remove the thermal protector mounting
screw.
4. Remove the thermal protector.
5. Reverse procedure to replace.
MAGNETRON ASSEMBLY REMOVAL
1. Unplug the power cord, remove the cabinet
and discharge the capacitor.
2. Remove the air guides and thermal protec-
tor from the magnetron.
3. Remove the four magnetron mounting
screws from the side of oven cavity.
4. Disconnect wire leads from magnetron and
replace on new magnetron, wire for wire.
5. Reverse the above procedure to reinstall
new magnetron and reassemble.
NOTE: DO NOT LOSE SCREWS, THEY
ARE M4 METRIC.
IMPORTANT: DO NOT OPERATE THE OVEN
WITH THE MAGNETRON DISASSEMBLED
FROM THE WAVEGUIDE.
IMPORTANT: MAKE SURE WIRE GASKET IS
PRESENT BEFORE INSTALLING MAG-
NETRON.