Reception Disturbances - Insignia NS-F27TV User Manual

Insignia television user guide
Table of Contents

Advertisement

Available languages

Available languages

Insignia NS-F27TV Television
Symptom
Possible cause
Poor or no
TV station is
picture
experiencing problems.
Picture control is not
adjusted.
Possible local
interference.
Antenna/cable
connector is not
connected.
Picture wobbles
TV station experiencing
or drifts
problems.
Cable TV channel is
scrambled.
Possible local
interference.
No cable
Cable not connected.
reception
Air/Cable set to Air.
Cable TV service
interrupted.
No reception
Air/Cable set to Air.
above CH13
Poor or no
TV station experiencing
sound
problems.
MUTE button is
pressed.
Possible local
interference.
Antenna/cable
connector is not
connected.
Volume is set to
minimum.
Television shuts
Sleep timer is set
off
Closed
TV signal is weak.
Captioning not
working
TV station experiencing
problems or program is
not closed captioned.
Close captioning is not
turned on.
Remote control
The remote control is
does not
not aimed at the
operate
sensor.
Distance is too far or
too much light in the
room.
There is an obstacle in
the path of the beam.
The batteries are weak. Replace the batteries.
The batteries are not
inserted correctly.
Parental control
Parental control is set
not working
to OFF.
correctly.
News or sports event
being broadcast.
Ratings not set.

Reception disturbances

Possible solution
Try another channel.
Check picture control
adjustments.
Check for source of
reception disturbance.
Check cable connection
or VHF/UHF antenna.
Try another channel.
A cable box needs to be
used to receive this
channel.
Check for source of
reception disturbance.
Check all cable
connections.
Set Air/Cable to Cable.
Contact your cable TV
company.
Set Air/Cable to Cable.
Try another channel.
Press MUTE button
again.
Check for source of
reception disturbance.
Check cable connection
of VHF/UHF antenna.
Increase the volume.
Set sleep timer to OFF.
Check cable or
VHF/UHG antenna.
Try another channel.
Press the CCD button.
Aim the remote control
at the remote sensor.
Operate the remote
within 15 feet of the
television or reduce the
light in the room.
Clear the path of the
beam.
Reinsert the batteries.
Set parental control to
ON.
Parental control does
not work with news or
sporting events.
Set ratings.
www.insignia-products.com
Most types of television interference can be
remedied by adjusting the height and position of
the VHF/UHF antenna. Outdoor antennas are
recommended for best results if not using cable
or satellite. The most common types of television
interference are shown below. If one of these
symptoms appear when the television is
connected to a Cable TV system, the
disturbance may be caused by the local cable
company broadcast.
IGNITION: Black spots or horizontal
streaks may appear, picture may
flutter or drift. Usually caused by
interference from automobile
ignition systems, neon lamps,
electric drills and other electric
appliances.
GHOSTS: Ghosts are caused by the
television signal following two
paths. One is the direct path and the
other is reflected from tall buildings,
hills, or other objects. Changing the
direction or position of the antenna
may improve the reception.
SNOW: If your receiver is located in
the fringe area of a television station
where the signal is weak, your
picture may be marred by the
appearance of small dots. When the
signal is extremely weak, it may be
necessary to install an external
antenna to improve the picture.
RADIO FREQUENCY
INTERFERENCE: This interference
produces moving ripples or
diagonal streaks, and in some
cases, causes loss of contrast in the
picture.
PICTURE SIZE VARIATION: A slight
picture size variation is normal
when you adjust the CONTRAST or
BRIGHTNESS setting.
17

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents