Connecting An Outside Antenna Or Cable Tv; Connecting A Standard Video Device - Insignia NS-R20C User Manual

Warning
Do not throw batteries into fire. Dispose of used
batteries as hazardous waste.
Caution
Do not drop or disassemble the remote control. Do
not get the remote control wet.
Caution
When the remote control will not be used for a
long period of time or when the batteries are word
out, remove the batteries to prevent leakage.
Connecting an outside antenna or cable
TV
To connect an antenna or cable TV:
1 Plug a 75-ohm cable into the antenna jack on
the back of your TV.
2 Plug the other end of the cable into a cable
TV or outside antenna source.
Note
If you use a 300-ohm flat cable, you need to
connect a 300-to-75-ohm converter to the flat
cable, then connect the converter to the antenna
jack on the back of your TV.
We recommend using a 75-ohm cable to reduce
interference caused by radio waves.
4

Connecting a standard video device

To connect a standard video device:
1 Plug a video cable into the VIDEO jack on the
front of your TV, then plug the other end of
the video cable into the VIDEO OUT jack on
the video device.
2 Plug the left and right audio cables into the
AUDIO L and AUDIO R jacks on the front of
your TV, then plug the other ends into the left
and right AUDIO OUT jacks on the device.
www.insignia-products.com
Insignia NS-R20C Round Tube TV
Non-S-Video device
To video out (yellow)
To L audio out (white)
To R audio out (red)
R AUDIO (red)
L AUDIO (white)
VIDEO (yellow)
Headphones