Installing Or Removing Saw Blade - Makita MLT100 Instruction Manual

008766
This tool is provided with the sub table (R) on the right
side of the main table. To use the sub table (R), loosen
two screws on the right side counterclockwise, pull out
the table (R) fully and then tighten the two screws to
secure it.
Sub table (back)
1
2
008768
To use the sub table (back), loosen the screws on the left
and right hand sides under the table and pull it out
backwards to the desired length. At the desired length,
tighten the screw securely.
Slide table
1
009707
This tool is provided with the slide table on the left side.
The slide table slides back and forth.
Hold workpiece firmly with the miter gauge using a
clamp on the miter gauge and slide the workpiece
together with the slide table at the time of cutting
operation.
1. Sub table (R)
1
1. Screws
2. Sub table (back)
1. Slide table
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
The tool is shipped from the factory with the saw blade
and blade guard not in the installed condition. Assemble
as follows:

Installing or removing saw blade

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before installing or removing the blade.
Use only the Makita socket wrench provided to
•
install or remove the blade. Failure to do so may
result in overtightening or insufficient tightening of
the hex bolt. This could cause an injury.
Use the following saw blade. Do not use saw
•
blades which
characteristics specified in these instructions.
For Model Max. dia.
MLT100 260 mm
008811
CAUTION:
Check the arbor hole diameter of the blade before
•
installing the blade. Always use the correct ring for
the arbor hole of the blade you intend to use.
1
008769
Remove the table insert on the table. Hold the outer
flange with the wrench and loosen the hex nut
counterclockwise with the wrench. Then remove the
outer flange.
Assemble the inner flange, ring, saw blade, outer flange
and hex nut onto the arbor, making sure that the teeth of
the blade are pointing down at the front of the table.
Always install the hex nut with its recessed side facing
the outer flange.
7
do not comply
Min. dia. Blade thickness
230 mm 1.8 mm or less 2 mm or more
1. Wrench
2
2. Wrench
3. Hex nut
3
with the
Kerf