Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Instruction Manual
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Kuzma STABI XL 4
Summary of Contents for Kuzma STABI XL 4
- Page 1 Fig.1 STABI XL 4 KIT- FOR CONVERTING STABI XL2 TURNTABLE Instruction manual 2010...
- Page 2 INSTRUCTION MANUAL FOR STABI XL 4 kit turntable The Stabi XL 4 KIT: converts Stabi XL2 turntable into Stabi XL 4 version. The difference is the addition of two extra motor towers to make 4 motor towers in total with 4 belts. These give more stable drive to the platter and there is a new better power supply.
- Page 3 Position each motor separately, one in front of the base(the motor tower with the Kuzma logo) and the second motor tower at the rear of the base so that the connectors are at the rear side. All four motor towers should form a square. The gap between the base and the motor towers should be at least 20 mm.
- Page 4 Power supply (PS XL 2=4=MCU): General description of PS: The AC motor power supply generates dual sine wave ouput to control rotation and speed of the AC sycnhronous motors. The signal is generated by quartz and controlled by a sophisticated computer based program. This allows for very smooth generation of the sine wave with very fine choice of speed.
- Page 5 Fine speed adjustment: Observe on a strobe disc if the bars are stationary. If not ( bars move in the same direction as platter rotation then the speed is too high) then press few times( there are very small steps- so keep pressing) the plus or minus buttons until the bars are stationary.
- Page 6 A.Speed:To reach correct speed, adjusted it on the PS. Also check that the distance of motors to the platter are correct. B.If the speed is totally incorrect: Reset to factory preset. Finally repeat factory preset and fine speed adjustment. Kuzma Ltd Hotemaze 17A SI-4205 PREDDVOR SLOVENIJA...
Need help?
Do you have a question about the STABI XL 4 and is the answer not in the manual?
Questions and answers