Location Of Controls (Cdx-Gt44Ip); Connections (Cdx-Gt44Ip) - Sony CDX-GT42IPW Service Manual

• LOCATION OF CONTROL (CDX-GT44IP)
Location of controls and basic operations
Main unit
1 2 3 4
OFF
PUSH SELECT
EQ3
SOURCE
SEEK SEEK
SCRL
MODE
DSPL
ALBUM
PTY
AF/TA 1
9 q; qa qs qd qf
Card remote commander
RM-X151
w;
1
OFF ATT
wa
4
SOURCE SEL MODE
qs
qj
+
ws
–
qk wd
DSPL SCRL
1 2 3
wf
4 5 6
+
ql
VOL
–
6

• CONNECTIONS (CDX-GT44IP)

A
AUDIO OUT
*
REAR
* AUDIO OUT SUB/REAR
B
AUDIO OUT
*
REAR
* AUDIO OUT SUB/REAR
5 6 7 8
AUX
REP SHUF PAUSE
2 3 4 5 6
qg qh
This section contains instructions on the location
of controls and basic operations. For details, see
the respective pages.
For iPod operation, see "iPod" on page 10. The
corresponding buttons on the card remote
commander control the same functions as those
on the unit.
A OFF button
To power off; stop the source.
B EQ3 (equalizer) button page 12
To select an equalizer type (XPLOD,
VOCAL, EDGE, CRUISE, SPACE,
GRAVITY, CUSTOM or OFF).
C Volume control dial/select button
page 12
To adjust volume (rotate); select setup items
(press and rotate).
D SOURCE button
To power on; change the source (Radio/CD/
AUX/PD).
E Disc slot
Insert the disc (label side up), playback
starts.
F Display window
G AUX input jack page 13
To connect a portable audio device.
H Z (eject) button
To eject the disc.
I
(front panel release) button page 5
CDX-GT42IPW/GT44IP/GT420IP
J DSPL (display)/SCRL (scroll) button
page 8, 9
To change display items (press); scroll the
display item (press and hold).
K SEEK –/+ buttons
CD/PD:
To skip tracks (press); skip tracks
continuously (press, then press again within
about 1 second and hold); reverse/fast-
forward a track (press and hold).
Radio:
To tune in stations automatically (press); find
a station manually (press and hold).
L MODE button page 8
To select the radio band (FM/MW/LW);
select the play mode of iPod.
M AF (Alternative Frequencies)/
TA (Traffic Announcement)/
PTY (Program Type) button page 9,
10
To set AF and TA (press); select PTY (press
and hold) in RDS.
N RESET button (located behind the front
panel) page 4
O Number buttons
CD/PD:
(1)/(2): ALBUM –/+ (during MP3/WMA
playback)
To skip albums (press); skip albums
continuously (press and hold).
(3): REP page 8
(4): SHUF page 8
(6): PAUSE
To pause playback. To cancel, press
again.
Radio:
To receive stored stations (press); store
stations (press and hold).
P Receptor for the card remote
commander
Connection example
Notes
• Be sure to connect the ground (earth) lead before connecting
the amplifi er.
• The alarm will only sound if the built-in amplifi er is used.
Anschlussbeispiel
Hinweise
• Schließen Sie unbedingt zuerst das Massekabel an, bevor Sie
den Verstärker anschließen.
• Der Warnton wird nur ausgegeben, wenn der integrierte
Verstärker verwendet wird.
Exemple de raccordement
Remarques
• Raccordez d'abord le câble de mise à la masse avant de
raccorder l'amplifi cateur.
• L'alarme est émise uniquement lorsque l'amplifi cateur intégré
est utilisé.
Esempio di collegamento
Note
• Assicurarsi di collegare il cavo di terra prima di collegare
l'apparecchio all'amplifi catore.
• L'allarme viene emesso solo se è in uso l'amplifi catore
incorporato.
Voorbeeldaansluitingen
Opmerkingen
• Sluit eerst de aardingskabel aan voordat u de versterker
aansluit.
• U hoort de pieptoon alleen als de ingebouwde versterker wordt
gebruikt.
The following buttons on the card remote
commander have also different buttons/functions
from the unit. Remove the insulation film before
use (page 4).
qj < (.)/, (>) buttons
To control CD/radio/PD, the same as
(SEEK) –/+ on the unit.
Setup, sound setting, etc., can be operated by
< ,.
qk DSPL (display) button
To change display items.
ql VOL (volume) +/– button
To adjust volume.
w; ATT (attenuate) button
To attenuate the sound. To cancel, press
again.
wa SEL (select) button
The same as the select button on the unit.
ws M (+)/m (–) buttons
To control CD/PD, the same as (1)/(2)
(ALBUM –/+) on the unit.
Setup, sound setting, etc., can be operated by
M m.
wd SCRL (scroll) button
To scroll the display item.
wf Number buttons
To receive stored stations (press); store
stations (press and hold).
Note
If the unit is turned off and the display disappears, it
cannot be operated with the card remote commander
unless (SOURCE) on the unit is pressed, or a disc is
inserted to activate the unit first.
7
7