General; Location Of Controls (Cdx-Gt32W/Gt320); Connections (Cdx-Gt32W/Gt320) - Sony CDX-GT32W Service Manual

• LOCATION OF CONTROL (CDX-GT32W/GT320)
Location of controls and basic operations
Main unit
1 2 3 4
OFF
PUSH SELECT
EQ3
SOURCE
SEEK SEEK
MODE
DSPL
BTM 1
9 q; qa qs qd qf
6

• CONNECTIONS (CDX-GT32W/GT320)

CDX-GT320/GT32W
A
AUDIO OUT FRONT
*
AUDIO OUT REAR
* AUDIO OUT SUB/REAR
CDX-GT320/GT32W
AUDIO OUT FRONT
*
AUDIO OUT REAR
* AUDIO OUT SUB/REAR
B
CDX-GT320/GT32W
Source selector*
Sélecteur de source*
XA-C40
SECTION 2

GENERAL

5 6 7 8
AUX
REP SHUF PAUSE
2 3 4 5 6
qg qh
This section contains instructions on the location
of controls and basic operations.
For details, see the respective pages.
For optional device (CD/MD changer, etc.)
operation, see "Using optional equipment" on
page 10. The corresponding buttons on the card
remote commander control the same functions as
those on the unit.
A OFF button
To power off; stop the source.
B EQ3 (equalizer) button page 9
To select an equalizer type (XPLOD,
VOCAL, EDGE, CRUISE, SPACE,
GRAVITY, CUSTOM or OFF).
C Volume control dial/select button
page 9
To adjust volume (rotate); select setup items
(press and rotate).
D SOURCE button
To power on; change the source* (Radio/CD/
AUX).
E Disc slot
Insert the disc (label side up), playback
starts.
F Display window
G AUX input jack page 10
To connect a portable audio device.
H Z (eject) button
To eject the disc.
I
(front panel release) button page 5
BUS AUDIO IN
* not supplied
BUS CONTROL IN
non fourni
CDX-GT32W/GT320/GT370/GT370S
J DSPL (display)/SCRL (scroll) button
(CDX-GT320/GT32W/GT220/GT22W)
page 8
To change display items (press); scroll the
display item (press and hold).
DSPL (display) button (CDX-GT120/
GT12W) page 8
To change display items.
K SEEK –/+ buttons
CD:
To skip tracks (press); skip tracks
continuously (press, then press again within
about 1 second and hold); reverse/fast-
forward a track (press and hold).
Radio:
To tune in stations automatically (press); find
a station manually (press and hold).
L MODE button page 8
To select the radio band (FM/AM)*.
M BTM/CAT button (CDX-GT320/GT32W)
page 8
To start the BTM function (press and hold).
BTM button (CDX-GT220/GT22W/
GT120/GT12W) page 8
To start the BTM function (press and hold).
N RESET button (located behind the front
panel) (CDX-GT320/GT32W only)
page 5
O Number buttons
CD:
(1)/(2): ALBM –/+ (during MP3/WMA
playback) (CDX-GT320/GT32W/GT220/
GT22W)
To skip albums (press); skip albums
continuously (press and hold).
(3): REP page 8
(4): SHUF page 8
(6): PAUSE
To pause playback of a CD on this unit.
To cancel, press again.
Radio:
To receive stored stations (press); store
stations (press and hold).
P Receptor for the card remote
commander (CDX-GT320/GT32W/
GT220/GT22W only)
Connection example
Notes (2- A )
• Be sure to connect the ground (earth) lead before connecting
the amplifi er.
• The alarm will only sound if the built-in amplifi er is used.
Tips (2- B )
• When connecting only a single CD/MD changer or other
optional device, connect directly to this unit.
• For connecting two or more CD/MD changers or other
optional devices, the source selector XA-C40 (not supplied) is
necessary.
Exemple de raccordement
Remarques (2- A )
• Raccordez d'abord le câble de mise à la masse avant de
raccorder l'amplifi cateur.
• L'alarme est émise uniquement lorsque l'amplifi cateur intégré
est utilisé.
Conseils (2 - B )
• En cas de raccordement d'un seul changeur de CD/MD
uniquement ou d'autres appareils en option, raccordez-le/les
directement à cet appareil.
• Le sélecteur de source XA-C40 (non fourni) est nécessaire
pour raccorder deux changeurs de CD/MD ou plus ou d'autres
appareils en option.
This section is extracted
from instruction manual.
The following buttons on the card remote
commander have also different buttons/functions
from the unit. Remove the insulation film before
use (page 5) (CDX-GT320/GT32W only).
qj < (.)/, (>) buttons
To control CD/radio, the same as (SEEK)
–/+ on the unit.
Setup, sound setting, etc., can be operated by
< ,.
qk DSPL (display) button
To change display items.
ql VOL (volume) +/– button
To adjust volume.
w; ATT (attenuate) button
To attenuate the sound. To cancel, press
again.
wa SEL (select) button
The same as the select button on the unit.
ws M (+)/m (–) buttons
To control CD, the same as (1)/(2) (ALBM
–/+) on the unit.
Setup, sound setting, etc., can be operated by
M m.
wd SCRL (scroll) button
To scroll the display item.
wf Number buttons
To receive stored stations (press); store
stations (press and hold).
* In the case of a CD/MD changer or SAT tuner being
connected; when (SOURCE) is pressed, the
connected device ("MD," "XM" or "SR") will appear in
the display, depending on which device is
connected. Furthermore, if (MODE) is pressed, you
can switch the changer, or SAT tuner band (CDX-
GT320/GT32W only).
Note
If the unit is turned off and the display disappears, it
cannot be operated with the card remote commander
unless (SOURCE) on the unit is pressed, or a disc is
inserted to activate the unit first.
7
5