Advertisement

custom audio electronics inc.
2x4
AUDIO CONTROLLER
OPERATING
GUIDE
10648 Magnolia Blvd. North Hollywood, CA. 91601 Phone (818) 763-8898 Fax (818) 763-8890

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 2x4 and is the answer not in the manual?

Questions and answers

Summary of Contents for Custom Audio Electronics 2x4

  • Page 1 • • • AUDIO CONTROLLER OPERATING GUIDE 10648 Magnolia Blvd. North Hollywood, CA. 91601 Phone (818) 763-8898 Fax (818) 763-8890...
  • Page 2 The 2x4 Audio Controller utilizes passive relay based switching in it’s signal path for the upmost sonic transparency. In addition, unlike other relay based switchers, the 2x4 uses 2 separate relays for each loop; 1 for the send, and 1 for the return.
  • Page 3: Front Panel Description

    15. “To RS-10” XLR connector. Used to connect CAE RS-10 MIDI Foot Controllers. Supplies 9VAC phantom power to the RS-10 on pins 1 and 2, and provides MIDI in to the 2x4 on pins 3 and 4. CAUTION: DO NOT USE BOTH THE FRONT...
  • Page 4: Rear Panel Description

    Rear Panel Description 1. Power input jack. 2.5mm center pin. Connect to a source of 9 to 12 VAC at 1amp. 2. MIDI In jack. 7 pin DIN. Connect to the output of a MIDI controller to control Loop/Control Function status. This jack also supplies 9/12 VAC phantom power on pins 6 &...

Table of Contents