Advertisement
WARNINg
Disconnect power and unplug the power cord
before attempting any maintenance or clean-
ing to reduce the risk of fire, electric shock
or personal injury. The bulbs in your unit can
become extremely hot. Allow at least 10 min-
utes between turning off the unit and removing
the light bulbs to avoid the accidental burning
of the skin.
FLAME EFFECT
The fire effect is created with the use of a 40
watt b-10 candelabra light bulb with an E-12
(small) socket base. The light bulb will have
to be replaced from time to time when they
burn out.
During normal operation the stove heater will
always give you simulated flame function. If
the intensity of flame suddenly increases, it
means that the light bulb is going to burn out.
Replace the light bulb immediately according
to the instruction and do not operate the stove
heater when the light bulb burns out or without
the light bulb.
M A I N T E N A N C E
CHANgINg THE
LIgHT bULb
STEP 1: Open the door of unit with the handle.
STEP 2: Loosen the 2 screws at the front of the
log set inside the stove. Carefully lift the logset
up far enough to access the light bulbs. You
will find 1 X 40W Type b-10 candelabra light
bulb with E-12 socket base at the bottom.
STEP 3: Replace the burned out light bulb
using a new 40 watt Type b-10 candelabra light
bulb.
STEP 4: Reinstall the logset.
STEP 5: Plug in the unit.
5
Advertisement
