Resetting The Grease Filter Operating Hours Counter - Miele DA 6000 W Operating Instructions Manual

Cleaning and care
Cleaning the grease filters by hand
^ Clean the filters with a soft nylon
brush in a mild solution of hot water
and a little washing-up liquid.
Do not use "neat" washing up liquid.
Do not use:
– cleaning agents containing
descaling agents,
– powder cleaners, cream cleaners or
abrasive all-purpose cleaners.
– oven sprays.
Cleaning the grease filters in the
dishwasher
^ Place the filters as upright as
possible in the lower basket, with the
short sides upright. Make sure that
the spray arm can move freely.
^ Do not wash at more than 65° C. If a
Miele dishwasher is being used,
select the Sensor wash programme.
^ Use a mild dishwasher detergent.
Depending on the cleaning agent
used, cleaning the filters in a
dishwasher can cause permanent
discolouration to the surface.
However, this will not affect the
functioning of the filters in any way.
^ After cleaning, leave the filters to dry
on an absorbent surface before
replacing them.
26
dai2507
^ Whilst the grease filters are removed,
to prevent the risk of fire, clean
grease deposits from the accessible
parts of the housing and the channel
in the lower part of the housing.
^ Replace the grease filters.
^ Close the canopy (see "To close the
housing").
^ The fan can be switched on again by
touching the power level sensor 1 to
4 required.
Resetting the grease filter operating
hours counter
After cleaning, the operating hours
counter needs to be reset.
^ Whilst the fan is switched on, touch
the Grease filter sensor l for
approx. 3 seconds until only the 1 is
flashing.
The Grease filter sensor l will go out.
If you want to clean the grease filters
before the operating hours counter has
reached its maximum,
^ Touch the Grease filter sensor l for
approx. 6 seconds until only the 1 is
flashing.