JVC KD-AR760 Service Manual page 8

3.1.4 Removing the front chassis
(See Figs.7 and 8)
• Prior to performing the following procedure, remove the front
panel assembly, heat sink and top chassis assembly.
(1) From the both sides of the top chassis assembly, remove
the two screws E attaching the front chassis. (See Figs.7
and 8)
(2) Take out the front chassis.
3.1.5 Removing the mecha control board
(See Fig.9)
• Prior to performing the following procedures, remove the front
panel assembly, heat sink and top chassis assembly.
Reference:
Remove the front chassis as required. (Refer to "3.1.4 Remov-
ing the front chassis")
(1) Disconnect the card wire from the connector
mecha control board.
(2) Remove the five screws F attaching the mecha control
board.
(3) Release the craw a, and take out the mecha control board.
Reference:
After attaching the mecha control board, attach it to the craw a
and pass the slot b of it into the boss of the CD mechanism as-
sembly.
1-8 (No.MA112)
Top chassis assembly
E
Mecha control board
CN601 on the
F
Slot b
Fig.7
Top chassis assembly
Front chassis
Fig.8
F
Fig.9
E
Front chassis
CN601
Craw a
F