Kärcher HD 1090 Safety Instructions page 4

GB
1 High-Pressure Nozzle
2 Spray Lance
3 Servopress Spray-Gun
4 Adjustment Wheel for Pressure and Flow
Regulation
5 High-Pressure Hose
6 Handle
7 Detergent Metering Valve
8 Screw Cap for Detergent Tank
9 Detergent Tank
10 Detergent Intake Hose with Filter
11 Fastening Screw for the Hood
12 Water Connection with Sieve
13 High-Pressure Connection
14 Unit Switch
15 Pressure Gauge
16 Fastening Screws for the Handle
1.1 Unpacking the unit
If, while unpacking, you discover damage
has been caused in transit, please inform
your dealer immediately.
Do not simply discard the packing materials
with the house-hold waste. Take the packing
materials to the appropriate collection areas
for recycling.
1.2 Checking the oil level
Unscrew both fastening screws from the left
and right side of the hood and remove the
hood.
Cut off the tip of the oil tank cap.
Check the oil level in the oil tank.
10
1. Starting
1.3 Assembling the accessories
Attach the handle to the unit with the supplied
screws.
Note: If the handle is too low for you, you
can change the height as follows:
– Remove the handle and hood.
– Unscrew the fastening nut for the
detergent tank and remove the tank.
– Unscrew the carry bar from the motor
unit (three screws) and remove to the
rear.
– Turn over the carry bar so that the top
and bottom are interchanged.
– Screw the carry bar back onto the motor
unit using the three new fastening holes.
This way, the carry bar is about 85 mm
higher.
– Reattach the detergent tank, hood and
handle.
Attach three-way nozzle to end of spray
lance in such a way that mark (1a) on adjusting
ring is on top.
Attach spray lance to handgun.
High-pressure hose
A- Lever off retaining clasp on handgun with
a screwdriver.
B- Stand handgun on end and while holding it in
this position, push end of hose into pistol as
far as end stop. At the same time, make sure
that loose disc on end of hose drops all way
to bottom.
C- Push retaining clasp back into handgun.
When attached properly, hose can only be
pulled outwards by approx. 1 mm. If hose can
be pulled out further, it must have been fitted
incorrectly.