Dodge Challenger SRT8 2012 User Manual page 66

ELECTRONICS
• Erase all channels before you begin programming. To erase the channels, place the
ignition switch into the ON/RUN position, then press and hold the two outside
HomeLink ® buttons (I and III) for up 20 seconds. The Electronic Vehicle
Information Center (EVIC) will display "CLEARING CHANNELS". Release the
buttons when the EVIC displays "CHANNELS CLEARED".
NOTE:
• Erasing all channels should only be performed when programming HomeLink
first time. Do not erase channels when programming additional buttons.
• If you have any problems, or require assistance, please call toll-free 1–800–355–
3515 or, on the Internet at www.HomeLink.com for information or assistance.
Programming A Rolling Code
• For programming Garage Door Openers that were manufactured after 1995. These
Garage Door Openers can be identified by the "LEARN" or "TRAIN" button located
where the hanging antenna is attached to the Garage Door Opener. It is NOT the
button that is normally used to open and close the door. The name and color of the
button may vary by manufacturer.
• Place the ignition switch into the ON/RUN position.
• Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink
button you wish to program while keeping the HomeLink
• Simultaneously press and hold both the HomeLink
and the hand-held transmitter button.
• Continue to hold buttons until the EVIC display changes from "CHANNEL #
TRAINING" to "CHANNEL # TRAINED", then release both buttons.
NOTE: If the EVIC displays "DID NOT TRAIN" repeat Programming A Rolling Code.
• At the garage door opener motor (in the garage), locate the "LEARN" or
"TRAINING" button. This can usually be found where the hanging antenna wire is
attached to the garage door opener motor. Firmly press and release the "LEARN"
or "TRAINING" button.
NOTE: You have 30 seconds in which to initiate the next step after the LEARN button
has been pressed.
64
Before You Begin Programming HomeLink®
• Be sure that your vehicle is parked
outside of the garage before you begin
programming.
• For more efficient programming and
accurate transmission of the
radio-frequency signal it is
recommended that a new battery be
placed in the hand-held transmitter of
the device that is being programmed to
the HomeLink ®
indicator light in view.
®
® button you want to program
system.
® for the
®