Specifications; Safety Precautions; Important Safety Instructions; Owner's Manual - Toshiba SD-130ESE Service Manual

Specifications

DVD video player / Outputs / Supplied accessories
DVD video player
Power supply 230~240 V AC, 50 Hz
Power consumption Operation: 8 W
Standby: 3 W
Mass 2.0 kg
External dimensions Width: 430mm
Height: 59mm
Depth: 207.5mm
Signal system PAL
Laser Semiconductor laser, wavelength 650/780 mm
Frequency response DVD: 4 Hz - 22 kHz
CD: 4 Hz - 20 kHz
Harmonic distortion 0.008 %
Wow and flutter Below measurable level
Temperature: 5 °C to 40 °C, Operation status: Horizontal
Operating conditions
Outputs
1.0 V (p-p), 75 Ω, negative sync., pin jack × 1
Video output
–12 dBm, 1 k Ω, pin jacks (L, R) × 1
Audio output (ANALOG)
0.7V (p-p), 75 Ω, SCART socket x 1
Audio/Video output (SCART)
0.5V (p-p), 75 Ω, pin jack × 1
Audio output (BITSTREAM/PCM
COAXIAL)
Supplied accessories
Remote control ..................................................... 1
Batteries (R03) ..................................................... 2
• Designs and specifications are subject to change without notice.
J2B52501A U
03/04

SAFETY PRECAUTIONS

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE. DANGEROUS HIGH VOLTAGES ARE PRESENT
INSIDE THE ENCLOSURE. DO NOT OPEN THE CABINET. REFER SERVICING TO
QUALIFIED PERSONNEL ONLY.
CAUTION: This Digital Video Disc Player employs a Laser System.
To ensure proper use of this product, please read this owner's manual carefully and retain for
future reference. Should the unit require maintenance, contact an authorized service location
-see service procedure.
Use of controls or adjustments or performance of procedures other than those specified herein
may result in hazardous radiation exposure.
To prevent direct exposure to laser beam, do not try to open the enclosure.
Visible and invisible laser radiation when open and interlocks defeated.
DO NOT STARE INTO BEAM.
CLASS 1
LASER PRODUCT
CAUTION: Servicing instructions are for use by qualified service personnel only. To reduce the risk of
electric shock do not perform any servicing other than that contained in the operating
instructions unless you are qualified to do so.
In the spaces provided below, record the Model and Serial No. located on the rear panel of your DVD video
player.
Model No. Serial No.
Retain this information for future reference.
The following information applies only to the model for U.K.
General Information
If the socket outlets in your home are not suitable for the plug supplied with this unit, the plug must be cut off
and an appropriate one fitted.
The plug severed from this mains lead must be destroyed as it is hazardous if inserted into a live socket.
IMPORTANT
The wires in this mains lead are coloured in accordance with the following code:
BLUE: NEUTRAL
BROWN: LIVE
As the colours of the wires in the mains lead of this unit may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
The wire that is coloured blue must be connected to the terminal in the plug which is marked with the letter N
or coloured black.
The wire that is coloured brown must be connected to the terminal which is marked with the letter L or
coloured red.
Do not connect either wire to the earth terminal which is marked by the letter E or by the safety earth symbol
or coloured green or green-and-yellow.
Use a 5A fuse which is approved by ASTA or BSI to BS1362.
Always replace the fuse cover after changing the fuse.
Location of the required label
The rating plate and the safety caution are on the rear of the unit.
2
Printed in Thailand
DIGITAL VIDEO
DVD VIDEO PLAYER
SD-130ESB

OWNER'S MANUAL

©2003 Toshiba Corporation

IMPORTANT SAFETY INSTRUCTIONS

CAUTION: PLEASE READ AND OBSERVE ALL WARNINGS AND INSTRUCTIONS GIVEN IN THIS
OWNER'S MANUAL AND THOSE MARKED ON THE UNIT. RETAIN THIS BOOKLET FOR
FUTURE REFERENCE.
This set has been designed and manufactured to assure personal safety. Improper use can result in electric
shock or fire hazard. The safeguards incorporated in this unit will protect you if you observe the following
procedures for installation, use and servicing. This unit is fully transistorized and does not contain any parts that
can be repaired by the user.
DO NOT REMOVE THE CABINET COVER, OR YOU MAY BE EXPOSED TO DANGEROUS VOLTAGE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL ONLY.
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in accordance with the
manufacturer's instructions.
3