Basic Tv Connections; Optional, Preferred Tv Connections - Zenith XBV243 Installation And Operating Manual

Connections (Continued)

Basic TV Connections

Make one of the following connections, depending on
the capabilities of your existing equipment.
RF coaxial connection
Connect the RF.OUT jack on the DVD+VCR to the
antenna in jack on the TV using the 75-ohm Coaxial
Cable supplied (R).
Note
If you use this connection, tune the TV to the
DVD+VCR's RF output channel (CH 3 or 4).
How to set the DVD+VCR's RF output channel
When the DVD+VCR is turned off, press and hold
CHANNEL (v/V) on the front panel for about five
seconds to change the RF output channel (CH 03 or
CH 04). "RF 03" or "RF 04" appears in the display
window.
Audio/Video connection
Connect the DVD/VHS VIDEO OUT jack on the
1 1
DVD+VCR to the video in jack on the TV using the
video cable supplied (V).
Connect the Left and Right DVD/VHS AUDIO OUT
2 2
jacks on the DVD+VCR to the audio left/right in
jacks on the TV (A1) using the supplied audio
cables.
Note
If you use this connection, set the TV's source selector
to VIDEO.
Rear of TV
VIDEO
AUDIO INPUT
INPUT
L R
A1 V R
Rear of DVD+VCR
ANTENNA
INPUT

Optional, Preferred TV Connections

Notes
DVD playback can ONLY be done using the AUDIO/
VIDEO connection options below.
For using S-VIDEO OUT or COMPONENT VIDEO OUT
jack, set the "TV Output Select" mode on the SETUP
menu to corresponding mode. See page 19.
Audio/Video connection
Connect the VIDEO OUT jack on the DVD+VCR to
1 1
the video in jack on the TV using the video cable
supplied (V).
Connect the Left and Right AUDIO OUT jacks of
2 2
the DVD+VCR to the audio left/right in jacks on the
TV using the audio cables supplied (A2).
S-Video connection
Connect the S-VIDEO OUT jack on the DVD+VCR
1 1
to the S-Video in jack on the TV using the supplied
S-Video cable (S).
Connect the Left and Right AUDIO OUT jacks of the
2 2
DVD+VCR to the audio left/right in jacks on the TV
using the supplied audio cables (A2). See page 19.
Component Video (Color Stream
Connect the COMPONENT VIDEO OUT jacks on
1 1
the DVD+VCR to the corresponding in jacks on the
TV using an optional Y Pb Pr cable (C).
Connect the Left and Right AUDIO OUT jacks of the
2 2
DVD+VCR to the audio left/right in jacks on the TV
(A2) using the supplied audio cables. See page 19.
Rear of TV
S-VIDEO
COMPONENT VIDEO INPUT
INPUT
Pr Pb
S C
Rear of DVD+VCR
® ) connection
VIDEO
AUDIO INPUT
INPUT
Y
R
L L
A2 V
13