Page 1
TROWEL-2 Digging Tool – Light and practical wide blade digging tool. TROWEL-W Bounty Hunter Baseball Cap – ® ® One size fits all, with Bounty Hunter logo. BHCAP Bounty Hunter T-Shirt – ® 100% cotton with Bounty Hunter ® Logo.
Page 2
TREASURE HUNTER’S CODE OF ETHICS: • Always check Federal, State, County and local laws before searching. • Respect private property and do not enter private property without the owner’s permission. • Take care to refill all holes and leave no damage. •...
Operation in the Field Sweep the searchcoil from side to side, in slow, overlapping motions. Keep the searchcoil parallel to the ground. Keep searchcoil 1/2” off the ground and try not to make contact with the ground. Try not to lift the searchcoil at the end of your sweeps. This may be difficult for younger children, but the closer the searchcoil is to the ground throughout the sweep, the more likely you are to find buried metal objects.
Sensitivity and Target Elimination Installing Batteries Use 9-volt ALKALINE batteries only! Adjusting Sensitivity 1. Remove the Battery Compartment Cover from the top of the The left knob clicks on to power the detector on. control housing. After turning on, the left knob is used to control the detector’s sensitivity level. In 2.
Page 5
Assembly Battery Test Click the right knob fully counterclockwise (all the way to the left), in order to test the batteries. If the batteries are good, the needle will move to the right and enter the green zone on the indicator label. If the needle does not enter the green zone, replace the batteries.
Adjusting Length Quick-Start Demo Loosen the tube Locking Collar 1/4 turn: Try this quick way to demonstrate the basic features of your metal detector: I. Supplies Needed a. A nail b. A zinc penny (pennies dated after 1982 are made of zinc) c.