Factory Test Mode - GE WPGT9350 Technical Service Manual

Factory Test Mode

The factory test mode allows the service tech to
make adjustments and run several important
tests on critical washer components.
1. Press the POWER pad to turn the washer on.
Press the HOME pad to ensure the home
screen is displayed.
TOUCH TO SELECT WASH CYCLE
COLOR
BY
SPECIAL
BY
FABRIC
CYCLES
2. Press the HELP pad. The main help screen is
displayed.
MACHINE
PREFERENCES
TROUBLESHOOTER
3. Press the HELP and START/STOP pads
simultaneously for 3 seconds. The Factory
Test Mode screen is displayed.
4. Press TEST LOAD on the LCD screen.
SPIN CYCLE
FILL/DRAIN/
SPIN
SPIN/
BRAKE
TEST LOAD
GARMENT
BY
STAIN
INSPECTOR
HOME SCREEN
HELP
CONTINOUS
SPIN
PROGRAM
CYCLE
LQC SPIN
LQC ALPHA
5. The contrast screen is displayed. This test
shows screen resolution, which affects how
the washer's graphics are displayed. Press
the START/STOP pad once to cycle through
the contrast screen (the black flips to the
opposite side).
6. Press the START/STOP pad. The TEST
LOAD screen is displayed.
TEST LOAD
TEST BRAKE RESISTOR
7. Using the test load screen:
Note: Read this section completely before using
the TEST LOAD screen.
a. Press the START/STOP pad to scroll
through the test list.
TEST LOAD
TEST BRAKE RESISTOR
TEST COLD VALVE
TEST HOT VALVE
TEST BLEACH VALVE
TEST SOFTNER VALVE
TEST SPECIAL ADDITIVE
WATER - LEVEL FREQUENCY
259
DRY LOAD SENSING DATA
124 002 140 002 237 003 122 003 067
139 047 038 038
TEST PUMP MOTOR
– 40 –
IPM TEMP
032
ATM TEMP
040
WATER TEMP
020
CONTRAST
90
IPM TEMP
032
ATM TEMP
040
WATER TEMP
020
CONTRAST
90