Setup; Loose Parts; Installing The Auxiliary Handle; Installing The Guard - Toro 51480 Operator's Manual

Setup

Loose Parts

Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
1

Installing the Auxiliary Handle

Parts needed for this procedure:
1. Position the auxiliary handle on the shaft of the trimmer with the
smooth surface facing the operator (Figure 1).
1. Auxiliary handle
2. Latch
2. Slide the brace into the auxiliary handle so that the brace rests in
the groove along the shaft (Figure 1).
3. Slide the latch from the left through the handle and brace as
shown and tighten the latch screw with a Phillips head screwdriver
(Figure 1).
Description
Auxiliary handle
Latch
Brace
Guard
Phillips head screw
No parts required
G017277
Figure 1
3. Brace
Qty.
1
1 Installing auxiliary handle.
1
1
Mounting the guard to the base of the
trimmer.
1
–
2

Installing the Guard

Parts needed for this procedure:
1. Slide the guard onto the trimmer base as shown in Figure 2.
1. Phillips head screw
2. Secure the guard using a Phillips head screw.
4
Use
Figure 2
2. Guard