Safety And Instructional Decals - Toro 51480 Operator's Manual

G. Keep cutting tools sharp and clean. Properly maintained
cutting tools with sharp cutting edges are less likely to bind
and are easier to control.
H. Use the power tool, accessories and tool bits etc., in
accordance with these instructions and in the manner
intended for the particular type of power tool, taking
into account the working conditions and the work to be
performed. Use of the power tool for operations different from
those intended could result in a hazardous situation.
I. Keep guards in place and in working order.
5. Service
A. Have your power tool serviced by a qualified repair
person using only identical replacement parts. This will
ensure that the safety of the power tool is maintained.
SAVE THESE INSTRUCTIONS
Extension Cord
WARNING
To reduce the risk of electrical shock use the trimmer only with an
extension cord intended for outdoor use, such as an extension
cord of cord type SW-A, SOW-A, STW-A, STOW-A, SJW-A,
SJOW-A, SJTW-A, or SJTOW-A.

Safety and Instructional Decals

Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace
any decal that is damaged or lost.
Symbol
AC
A
Hz
RPM
V
Name
Alternating current
Amperes
Hertz
Revolutions per minute
Volts
ID-1006
Ensure that your extension cord is in good condition. When using
an extension cord, use one heavy enough to carry the current your
product will draw. An undersized extension cord will cause a drop in
line voltage resulting in loss of power and overheating. The following
table lists the correct cord size depending on the length of the cord.
If you are in doubt, use the next heavier gage. The smaller the gage
number the heavier the gage.
Extension Cord Length
100 ft.
150 ft.
Note: Do not use an extension cord over 150 feet.
To reduce the risk of disconnection of the extension cord during
use, connect the extension cord to the trimmer as illustrated in the
Operation section of this manual.
Designation/Explanation
Type of current
Current
Frequency (cycles per second)
Speed of string
Voltage
2
Minimum Wire Gage (A.W.G.)
16
14
ID-1009