Nokia X6-00 User Manual page 138

138 Connectivity
2 Open the access point group that has the desired WLAN access point, and select
the access point.
You can also define 802.1x or WPA/WPA2 settings when creating a new WLAN
access point.
3 Select WLAN security mode
4 Select WLAN security settings
authentication protocol (EAP) plug-in, or
The same password must be entered on the WLAN access point device.
If you selected EAP, define the EAP plug-in settings according to the instructions
from your service provider.
Connections in WPA2 only mode are applicable to WPA2 enabled devices only.
The available options may vary.
Advanced WLAN settings
1 Select Menu
2 Open the access point group that has the desired WLAN access point, and select
the WLAN access point.
You can also define advanced WLAN settings when creating a new WLAN access
point.
3 Select Options
IPv4 settings — Enter the IP address of your device, the subnet IP address, the
default gateway, and the IP addresses of the primary and secondary DNS servers.
For these addresses, contact your internet service provider.
IPv6 settings — Define the type of DNS address.
Ad-hoc channel (only for Ad-hoc) — To enter a channel number (1-11) manually,
select User defined.
Proxy server address — Enter the address for the proxy server.
138
Settings and Connectivity
>
Advanced settings, and define the following:
>
WPA/WPA2 or 802.1x.
>
WPA/WPA2
>
Pre-shared key
> Destinations.
EAP to use an extensible
>
to use a password.
© 2009 Nokia. All rights reserved.