Troubleshooting - sunjoe SPX3000 Operator's Manual

2030 psi/1.76 gpm electric pressure washer
Hide thumbs Also See for SPX3000:
Table of Contents

Advertisement

Troubleshooting

• Disconnect the unit from the electrical power supply before carrying out maintenance on the machine or when checking that
its parts are in proper working order.
• To avoid unnecessary disappointments, you should check the following before contacting the service organization:
Problems
Possible Cause
Machine refuses
• Power failure/machine not plugged
to start
• Defective socket.
• Fuse has blown.
• Defective extension cord.
Fluctuating pressure
• Pump sucking air.
• Valves dirty, worn out or stuck.
• Pump seals worn out.
Machine stops
• Fuse has blown.
• Incorrect mains voltage.
• Thermal sensor activated.
• Nozzle partially blocked.
Fuse blows
• Fuse too small.
Machine pulsating
• Air in inlet hose.
• Inadequate supply of mains water.
• Nozzle partially blocked.
• Water filter blocked.
• Hose kinked.
Machine often starts
• Pump/spray gun is leaking.
and stops by itself
Machine starts, but
• Pump/hoses or accessories frozen.
no water comes out
• No water supply.
• Water filter blocked.
• Nozzle blocked.
into a working receptacle.
Possible Solution
• Check to make sure machine is plugged into
a working outlet.
• Replace fuse. Switch off other machines.
• Try without the extension cord.
• Check the hoses and connections are airtight.
• Clean and replace or refer to local distributor.
• Check that the mains voltage corresponds to
specification on the model tag.
• Leave the washer for 5 minutes to cool down.
Clean the nozzle.
• Change to an installation higher than the amp
consumption of the machine. You may try without the
extension cord.
• Allow machine to run with open trigger until regular
working pressure resumes.
• Check that the water supply corresponds to
specifications required.
• WARNING! Avoid using long, thin hoses (min. 1/2 in.).
• Clean the nozzle.
• Clean the filter.
• Straighten out hose.
• Please call 1-866-766-9563 for assistance.
• Wait for pump/hoses or accessories to thaw.
• Connect inlet water.
• Clean the filter.
• Clean the nozzle.
11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents