Model Min; Max; Output Control - Nemic-Lambda ZUP6-33 User Manual

5.5.3 Output control

# Commands
1 :VOLn;
2 :VOL!;
3 :VOL?;
4 :CURn;
Description
Sets the output voltage value in volts. This programmed voltage is the
actual output at constant-voltage mode or the voltage limit at constant
current mode. The range of the voltage values are as shown in table 5-1.
Use all digits for voltage programming
Model MIN.
ZUP6-XY 0.000
ZUP10-XY 00.000
ZUP20-XY 00.000
ZUP36-XY 00.00
ZUP60-XY 00.00
Table 5-1: Voltage programming range.
Example- :VOL5.010;
Returns the string SV
value. The actual voltage range is as shown in table 5-1.
example: SV5.010
Returns the string AV followed by the actual output voltage. The actual
voltage range is the same as the programming range.
example: AV5.010 AV08.500
Sets the output current in Ampers. This programmed current is the actual
output current at constant-current mode or the current limit at constant
voltage mode. The programming range is shown in table 5-2:
Use all digits for current programming.
Model MIN.
ZUP6-33 00.00
ZUP6-66 00.00
ZUP6-132 000.00
ZUP10-20 00.000
ZUP10-40 00.00
ZUP10-80 00.00
ZUP20-10 00.000
ZUP20-20 00.000
ZUP20-40 00.00
ZUP36-6 0.000
ZUP36-12 00.000
ZUP36-24 00.000
ZUP60-3.5 0.000
ZUP60-7 0.000
ZUP60-14 00.000
Table 5-2: Current programming range.
Example- :CUR3.000;

MAX.

Note:
6.000
The ZUP can accept programmed value
10.000
higher by up to 5% than the table values,
however it is not recommended to program
20.000
power supply over the rated voltage.
36.00
60.00
:VOL08.500;
followed by the present programmed output voltage
SV08.500
MAX.
Note:
33.00
The ZUP can accept values higher by 5%
66.00
than the rating. It is recommended to set the
output current to 105% of the rating if the
132.00
unit is required to supply the rated current.
20.000
40.00
80.00
10.000
20.000
40.00
6.000
12.000
24.000
3.500
7.000
14.000
:CUR07.50;
43