Table of Contents
Advertisement
For Parts Call 606-678-9623 or 606-561-4983
For Parts Call 606-678-9623 or 606-561-4983
Shear Pin Storage
An area for convenient shear pin storage is located under
the plastic dash panel. See Figure 6.
Chute Clean-Out Tool
The clean-out tool is conveniently fastened to the rear
of the auger housing with a mounting clip and secured
with a cable tie at the factory. Cut the cable tie before
operating the snow thrower. See Figure 10.
WARNING: Never use your hands to clean
snow and ice from the chute assembly or
auger housing.
Tire Pressure
The tires are over-inflated at the factory, for shipping
purposes. Check the tire pressure before operating the
snow thrower. Reduce pressure in both tires to between
15 psi and 20 psi.
NOTE: If the tire pressure is not equal in both tires, the
unit may not travel in a straight path and the shave plate
may wear unevenly.
www.mymowerparts.com
www.mymowerparts.com
Figure
Figure 6
Figure
3
Setting Up
Your Snow
Thrower
CAUTION
Prior to operating
your snow thrower,
refer to Auger Control
Test on page 13.
Read and follow all
instructions care-
fully and perform all
adjustments to verify
your unit is operating
safely and properly.
IMPORTANT
Under any circum-
stance do not exceed
manufacturer's recom-
mended psi. Equal tire
pressure should be
maintained at all times.
Excessive pressure
when seating beads
may cause tire/rim
assembly to burst
with force sufficient to
cause serious injury.
Refer to sidewall of
tire for recommended
pressure.
Advertisement
Table of Contents
