Replacing Carbon Brushes; Optional Accessories; After Use - Makita BLS713 Instruction Manual

(2) 45° bevel angle
003945
Adjust the 45° bevel angle only after
performing 0° bevel angle adjustment. To
adjust left 45° bevel angle, loosen the lever
and tilt the blade to the left fully. Make sure
that the pointer on the arm points to 45° on
the bevel scale on the arm holder. If the
pointer does not point to 45°, turn the 45°
bevel angle adjusting bolt (upper bolt) on the
right side of the arm until the pointer points to
45°.

Replacing carbon brushes

001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
011307
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps.

After use

After use, wipe off chips and dust adhering to the
•
tool with a cloth or the like. Keep the blade guard
clean according to the directions in the previously
1. Left 45 ﾟ bevel
angle adjusting
bolt
1
1. Limit mark
1
1. Brush holder cap
2. Screwdriver
1
2
covered section titled "Blade guard". Lubricate the
sliding portions with machine oil to prevent rust.
When storing the tool, pull the carriage toward you
•
fully so that the slide pole is thoroughly inserted into
the turn base.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers, always
using Makita replacement parts.

OPTIONAL ACCESSORIES

WARNING:
These Makita accessories or attachments are
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments may result in serious
personal injury.
Only use the Makita accessory or attachment
•
for its stated purpose. Misuse of an accessory or
attachment may result in serious personal injury.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Carbide-tipped saw blades
•
Vise assembly (Horizontal vise)
•
Vertical vise
•
Socket wrench 10
•
Holder set
•
Holder assembly
•
Holder rod assembly
•
Set plate
•
Dust bag
•
Triangular rule
•
Hex wrench
•
Various type of Makita genuine batteries and
•
chargers
NOTE:
Some items in the list may be included in the tool
•
package as standard accessories. They may differ
from country to country.
19