Advertisement
of any further procedures that may be required, including an RMA number in the event that
the unit has to be returned to the factory for repair.
Make sure the following items are included inside the package:
• One DP140e Power Supply Unit.
• One AC Power Cord.
• One warranty card.
• One Installation and Operations Manual.
• Mounting Instruction.
Location Requirements
Electrical Requirements
• The DP140e requires 120 VAC, 60hz commercial power for operation. If 230 VAC
operation is required, please notify the factory. The DP140e should not be placed on
a circuit with other equipment. A separate circuit should be run to the closet for
powering the DP140e.
• Each unit requires a separate NEMA 5 - 15R receptacle.
• A standard 7 foot 6 inch power cord with a molded NEMA 5 - 15 plug is supplied
with each unit.
Environmental Requirements
• A clean dry location should be picked for installing this unit.
Mounting Instructions
• When mounting, keep in mind the DP140e weighs 19 lbs., and the DP140e-8 weighs
32lbs.
• The DP140e is designed to mount to a wall, a 19 inch rack, a 23 inch rack and a 25
inch rack. For wall mounting, it is recommended to use a 3/4 inch plywood
backboard.
• Whether the unit is to be wall or rack mounted, it should be mounted vertically.
• It is important that the power supply be given adequate ventilation above, below and
on both sides of the unit.
• The DP140e comes standard for wall mount or 19 in rack mount. Optional mounts for
23 and 25 in racks are available.
5
Advertisement
