Reset The Camera - LevelOne FCS-5053 User Manual

Hardware Manual

Reset the Camera

In case there is a need to reset the camera to its default factory settings, do the following
procedures while the camera is powered on.
1. Loosen the three (3) screws securing the back cover.
NOTE: A cable is connected inside the camera, do not abruptly pull the back cover.
2. Press and hold the Reset button for 5 seconds to reset the camera.
3. When done, ensure the rubber seal is aligned and attached to the back cover and then
close the back cover by tightening the three (3) screws.
CAUTION: Make sure the rubber seal is properly attached and the back cover is closed to
ensure water or dust cannot enter the camera.
23