Infinity Beta 10 Owner's Manual page 4

W S
IRING THE YSTEM
IMPORTANT: Make sure all equipment is turned off before making any
connections.
For speaker connections, use a high-quality speaker wire with polarity
coding.The side of the wire with a ridge or other coding is usually
considered positive polarity (i.e., +).
NOTE: If desired, consult your local Infinity dealer about speaker wire and
connection options.
The speakers have coded terminals that accept a variety of wire connec-
tors.The most common connection is shown in Figure 4.
To ensure proper polarity, connect each + terminal on the back of the
amplifier or receiver to the respective + (red) terminal on each speaker,
as shown in Figure 5. Connect the – (black) terminals in a similar way.
See the owner's guides that were included with your amplifier, receiver
and television to confirm connection procedures.
IMPORTANT: Do not reverse polarities (i.e., + to – or – to +) when
making connections. Doing so will cause poor imaging and diminished
bass response.
Figure 4.This figure shows how to connect bare wires to the terminals.
Beta 10, Beta 20, Beta C250 and Beta C360
Figure 5. Wiring diagram shows polarity connections for one
channel of a stereo or home theater system.
BETA SPEAKER SYSTEMS
4
Beta 40 and Beta 50
Figure 6.This example shows how to connect bare wires to the
terminals. Banana plugs may also be inserted directly into the rear
of the connector.
Figure 7. Wiring diagram shows polarity connections for one channel
of a stereo or home theater system.