One-2-Punch Specialized Router For PNCH-1 Non-Linear Editing Applications You have just purchased the most innovative, flexible and powerful system interface available today. The One-2-Punch is the ultimate product for solving all your non-linear edit system signal and device routing needs. Designed and developed by both engineers and top video production editors, the One- 2-Punch was designed for user friendly setup &...
Page 4
One-2-Punch Specialized Router For PNCH-1 Non-Linear Editing Applications FRONT PANEL SELECTORS As stated, the front panel is divided into 2 identical sections designated as SOURCE and RECORD. Each section has 3 toggle switches located between 2 LEDs: one green and the other red. Located below each of these switches is another toggle switch designated SOLO and AUTO.
CABLES:TecNec manufactures all cables, adapters and accessories to complete your system. Once you have determined your sys- tem needs, call your TecNec dealer for delivery of any and all cables. We also manufacture custom length cables and harnesses. ADDITIONAL EQUIPMENT: TecNec is also your source for all your audio-video professional equipment and accessories.
SVHS: Since the One-2-Punch has 3 video lines per device, it is simple to use SVHS equipment. A 4-Pin (SVHS) to BNC break- out cable is available: TecNec part# SV4-2B-6. With this cable simply connect the BNC labeled Y and C to the corresponding Y and C overlay labeled connectors on the One-2-Punch.
Page 11
What you feed it will be returned to you likewise. UNBALANCED AUDIO: Should your system requirements call for unbalanced audio, you may use TecNec cable part# SC6XR to adapt the XLR port to RCA phono. Part# SC6XS can be used for XLR to 1/4" phone (tip-ring).
Page 12
One-2-Punch Specialized Router For PNCH-1 Non-Linear Editing Applications “CONTROL” TOGGLE OPERATION HOW EXACTLY DOES THE FRONT PANEL "CONTROL" TOGGLE SWITCH WORK? CONTROL TOGGLE SWITCH Located directly above and between the Two AUTO switches is the RS422 control selector switch. This feature addresses the fact that Non-Linear Edit Systems usually only have one RS422 bi-directional port.
Page 13
One-2-Punch Specialized Router For PNCH-1 Non-Linear Editing Applications Diagram 2A: 2 MACHINE SYSTEM: 2 VTRS WHERE THE VTRS ARE BEING USED FOR BOTH DOWNLOAD AND RECORDING In this configuration, the One-2-Punch is controlling 2 VTRs in total, where one or...
Page 14
One-2-Punch Specialized Router For PNCH-1 Non-Linear Editing Applications Diagram 2C: 2 Non-Linear Editors Controlling 2 VTRS Each: for Download & Recording VTR D VTR B VTR C VTR A REC-1 SOURCE-1 REC-2 SOURCE-2 NLE 1 NLE 2 Here 2 NLE units are being used with 2 VTRs each. Connect the 9 pin cables from VTRs A, B to the source RS422 ports, and NLE#1 to the source output port located directly below the Source-1, Source-2 input 9 pin ports.