Infinity RS KAPPA PS-8 Owner's Manual page 5

S C
UBWOOFER ONNECTIONS
C S
HOOSE THE UBWOOFER
If you have a Dolby* Digital or DTS
low-frequency-effects (LFE) or subwoofer output:
SUBWOOFER OR
LFE OUTPUT
OUT
+
If your receiver/processor does
not have subwoofer outputs for
the left and right channels or an
LFE output, connect speaker
wire from your receiver/amplifier
to your speakers and subwoofer
using two sets of speaker wire:
RECEIVER/AMPLIFIER
Front Speaker Output
C T I
ONNECTION HAT S
® receiver/processor with a
IN
+
HIGH LEVEL INPUT
+
–
L R
M S Y
OST UITABLE FOR OUR
If your receiver/processor does not contain a Dolby Digital or DTS
processor but has a subwoofer output:
OUT IN
+
NOTE: Some receivers have one subwoofer output.
In that case, it is recommended that you use a Y connector
(not included) to maximize performance.
BLACK =
1. LOOSEN TERMINALS
2. INSERT BARE END;
TIGHTEN TERMINALS
NO STRIPE =
This figure shows how to connect bare wires
to the terminals.
R /P
ECEIVER ROCESSOR
RECEIVER/PROCESSOR
L R
+
+
RED =
–
– +
STRIPE =
PS-8
5