Page 1
PS-10 PS-12 PS Series Powered Subwoofers SERVICE MANUAL Infinity Systems Incorporated 250 Crossways Park Dr. Woodbury, New York 11797 Rev1 10/2004...
PS-10/PS-12 PS-10 Powered Sub/ Plate Amp LINE VOLTAGE Yes/No Hi/Lo Line Nom. Unit Notes US 120vac/60Hz 108-132 Vrms Normal Operation EU 230vac/50-60Hz 207-264 Vrms Normal operation, MOMS required QA Test Parameter Specification Unit Conditions Notes Limits Amp Section Type (Class AB, D, other)
Page 4
PS-10/PS-12 Turn-on Transient mV-peak 2V-pk-pk @ Speaker Outputs AC Line cycled from OFF to ON Turn-off Transient mV-peak 2V-pk-pk @ Speaker Outputs AC Line cycled from ON to OFF Efficiency Efficiency Nominal Line voltage 120 VAC Maximum allowable input power under nominal...
PS-10/PS-12 PS-12 Powered Sub/ Plate Amp LINE VOLTAGE Yes/No Hi/Lo Line Nom. Unit Notes US 120vac/60Hz 108-132 Vrms Normal Operation EU 230vac/50-60Hz 207-264 Vrms Normal operation, MOMS required QA Test Parameter Specification Unit Conditions Notes Limits Amp Section Type (Class AB, D, other)
Page 6
PS-10/PS-12 QA Test Parameter Specification Unit Conditions Notes Limits Transients/Pops ATO Transient mV-peak @ Speaker Outputs Turn-on Transient mV-peak 2V-pk-pk @ Speaker Outputs AC Line cycled from OFF to ON Turn-off Transient mV-peak 2V-pk-pk @ Speaker Outputs AC Line cycled from ON to OFF...
PS-10/PS-12 ONTROLS AND ONNECTIONS Rear Panel ¡ Subwoofer-Level Control ™ LFE/Normal Selector • ¡ £ Phase Switch Green: On Red: Stand-By ¢ Crossover Adjustment ™ NORMAL ∞ Line-Level/LFE Input £ 0º 180º § Speaker-Level Inputs 80Hz ¶ Power Switch ¢...
Page 8
PS-10/PS-12 YSTEM ONNECTIONS If your receiver/processor does not have subwoofer outputs for the left and right channels or an LFE output, connect LEVEL If you have a Dolby* Digital or Green: On speaker wire from your receiver/amplifier Red: Stand-By ®...
Adjust the Subwoofer-Level Control until you obtain a pleas- event that your subwoofer ever needs service, contact your local Infinity ing blend of bass. Bass response should not overpower the room but dealer or Infinity directly at 1.516.674.4INF or www.infinitysystems.com rather be adjusted so there is a harmonious blend across the entire musi- for a service center near you.
PS-10/PS-12 PS-10/12 Test Set Up and Procedure SYSTEM AURAL SWEEP TEST Equipment needed: • Function/signal generator/sweep generator • Integrated Amplifier • Multimeter • Speaker cables General Unit Function (UUT = Unit Under Test) Switches/knobs on the amplifier faceplate: LFE/Normal to "Normal"...
Subject: Replacing Output MOSFETS In the event you need to replace MOSFET transistors Q18 or Q22 as part of a repair: It is important to use ONLY the Infinity part# FE106401110, 051-640001-000, or only the brands: International Rectifier, or Fairchild.
PS-10/PS-12 PS-10 Exploded View Ref. # Part Number Description Not For Sale PS-10 AMPLIFIER 1 EA Not For Sale PS-10 CABINET 1 EA 351650-001 TRIM RING, 10"-PS10 1 EA 333249-001 CUP, GRILLE 4 EA 351781-001 LOGO - PS10/PS12 1 EA 330163-001 FOOT, PLASTIC, 1"...
PS-10/PS-12 PS-12 Exploded View Ref. # Part Number Description Not For Sale PS-12 AMPLIFIER 1 EA Not For Sale PS-12 CABINET 1 EA 351651-001 TRIM RING, 12"-PS12 1 EA 333249-001 CUP, GRILLE 4 EA 351781-001 LOGO - PS12/PS12 1 EA 330163-001 FOOT, PLASTIC, 1"...