System Connections - Infinity PS210W Owner's Manual

S C
YSTEM ONNECTIONS
Choose either Wireless or Wired Connection; then follow the appropriate instructions.
WIRELESS
Connecting the Subwoofer for Wireless Applications
ID
CODE
DC18V
1 2 3 4
Step 1.
Connect a subwoofer cable from the subwoofer or LFE output of
your receiver to the Sub In › on the transmitter.
Step 2.
Plug the transmitter module into the wall outlet, and connect the
included power supply and power cord to the transmitter
sure the Transmitter Antenna ⁄ is extended upward.
Step 3.
Set the ID Code on the transmitter ‹ and subwoofer ¢ to the
same position, as described on page 6. When connected properly,
the LED on the rear of the subwoofer will be orange.
Step 4.
Set the Low-Pass Selector § to the "Off" position.
NOTE: Some receivers have two subwoofer outputs. In that case,
use either connector.
WIRED
Connecting the Subwoofer for Wired Applications
If you have a Dolby
a low-frequency effects (LFE) or subwoofer output:
Sub In
. Make
If your receiver/processor does not contain a Dolby Digital
or DTS processor, but has subwoofer outputs:
NOTE: If your receiver/processor has only one sub out, you
may use either the L or R input.
® Digital or DTS ® receiver/processor with
PS210W, PS212W (120V)
5