Marantz SR4023 User Manual page 12

ENGLISH
CONNECTING ASUBWOOFER
Use the PRE OUT SUBWOOFER jack to connect a
powered subwoofer (power amplifier built in).
5.
2.
S ( "
.~
1.
~
1.----.1
10mm
(3/8inch)
3.
CONNECTING SPEAKER WIRE
1.
Strip away approx. 10 mm (3/8inch) of wire
insulation.
2.
Twist the bared wire ends tight, to prevent short
circuits.
3.
Loosen the knob by turning it counterclockwise.
4.
Insert the bare part of the wire into the hole in
side of each terminal.
5.
Tighten the knob by turning it clockwise to
secure the wire.
Caution:
• Be sure to use speakers with the specified impedance
as shown on the rear panel of this unit.
• To prevent damage to circuitry, do not let the bare
speaker wires touch each other and do not let them
touch any metal part of this unit.
• Do not touch the speaker terminals when the power
is on. II may cause you to receive an electric shocks.
• Do not connect more than one speaker cable to one
speaker terminal. Doing so may damage this unit.
System A
Powered
subwoofer
r
'I
CONNECTING SPEAKERS
Note:
Be sure to connect the positive and negative cables for
the speaker properly. If they are miss-connected, the
signal phase will be reversed and the signal quality
will be corrupted.
9