Table of Contents
Advertisement
3. OPERATION
This section describes how to select a computer or video source, how
to adjust the picture, and how to customize the settings.
Connecting the Power Cable and Turning on the
Rear projection display
Before you turn on your rear projection display, ensure that the com-
puter or video source is turned on.
1. Connect the supplied power cable to the rear projection display.
Plug the supplied power cable in the wall outlet and then press the
main power switch [ I ] on the rear terminal panel. The rear projec-
tion display will go into its standby mode and the power indicator will
glow orange.
O N
M A
IN
P O
W E
R
O F
F
A C
IN
To turn on the rear projection display:
Only after you press the "ON/STAND BY" button on the cabinet or "POWER ON" button on the remote control will the power indicator turn to green
and the rear projection display become ready to use.
NOTE: To turn the rear projection display on by pressing the main power switch [ I ], use the menu and enable the "Auto Start" feature. (See page E-35.)
NOTE: Immediately after turning on the rear projection display, screen flicker may occur. This is not a fault. Wait 3 to 5 minutes until the lamp lighting is stabilized.
Status of Indicators:
Stand by
OFF
STATUS
POWER
Steady orange light
Main power switch
STATUS
POWER
Lamp Mode:
Normal mode
POWER indicator flashing in
green for 1 minute.
ON
POWER
STATUS indicator flashing in
green for 3 minutes. During this
period of time Normal mode is
forcefully selected.
Lamp Mode:
Eco mode
STATUS
POWER
POWER indicator flashing in
green for 1 minute.
E – 24
2. Turn on and off the Rear projection display.
OFF
VIDEO
S-VIDEO
SELECT
STATUS
POWER
ON/STAND BY
STATUS
POWER
POWER indicator steady
light in green.
STATUS indicator steady
light in green (Eco mode)
STATUS
POWER
POWER indicator steady
light in green.
ON
POWER
RGB
AUTO ADJ.
S-VIDEO
VIDEO
Advertisement
Table of Contents
