Table of Contents
Advertisement
Remote Control Battery Installation
1. Press firmly and slide the battery cover off.
2. Remove both old batteries and install new ones (AA). Ensure that
you have the batteries' polarity (+/–) aligned correctly.
Do not mix different types of batteries or
new and old batteries.
3. Slip the cover back over the batteries until it snaps into place.
Note on Remote Control Operation:
Pressing and holding the SELECT
stalling new batteries may cause malfunction or no operation.
Should this happen, remove the batteries and then install them again
without touching the SELECT
(Mouse) button while in-
(Mouse) button.
E – 14
Operating Range
30˚
30˚
30˚
30˚
Remote Control Precautions
• Handle the remote control carefully.
• If the remote control gets wet, wipe it dry immediately.
• Avoid excessive heat and humidity.
• If you will not be using the remote control for a long time, remove the
batteries.
Do not change the settings of the function (DIP) switches.
There are two switches on the bottom of the battery case.
For normal operation, these function switches are not used.
Be sure to leave the No.1 switch at its original factory setting (ON).
Do not change the setting of the No. 1 switch. Failure to do so will cause
incorrect movement in SELECT
STATUS
STATUS
POWER
POWER
ON/STAND BY
ON/STAND BY
S-VIDEO
S-VIDEO
VIDEO
VIDEO
SELECT
SELECT
RGB
RGB
AUTO ADJUST
AUTO ADJUST
L / MONO
L / MONO
R
R
FRONT/
FRONT/
REAR
REAR
RGB INPUT
RGB INPUT
AUDIO
AUDIO
S-VIDEO
S-VIDEO
VIDEO
VIDEO
AUDIO
AUDIO
22 feet / 7m
,
,
,
(mouse) buttons.
Function (DIP) Switches
Advertisement
Table of Contents
