Table of Contents
Advertisement
Set Position This reorients your image for your type of projection. Press the (+) button
until you have the correct image orientation. It moves sequentially: front floor projec-
tion - rear ceiling projection - rear floor projection - front ceiling projection. Press the(-
) to move backward through the sequence.
Maintenance Icons
Picture Adjustment Use this icon with the "Fine Picture Adjustment" to
fine tune the computer image or to remove any vertical banding that might
appear. This function adjusts the clock frequencies that eliminate banding in
the image. Press the (+) and (-) buttons until the banding disapears. This
adjustment may be necessary when you hook your computer up for the first
time. This adjustment is made automatically when the Auto Picture is
turned on.**
Fine Picture Adjustment Use this icon to adjust the clock phase or to
reduce video noise, dot interference or cross talk. (This is evident when
parts of the image apear to be shimmering.) Use the (+) and (-) buttons to
adjust the image. Use the Fine Picture Adjustment only after the Picture
Adjustment is complete. This adjustment is made automatically when the
Auto Picture is turned on.**
Using A Tabletop Or Cart
1. Place your LCD projector on a flat level surface at the optimal distance from
the screen or wall so you realize the size image you want. (Avoid having
bright room lighting or sun light directly on the screen or wall where you'll
be projecting the image.)
2. Connect the power cable, remove the lens cap and turn the projector on. (If
no input signal is available, the projector will display a black screen.)
3. Ensure that the projector is square to the screen.
4. Move the projector left or right to center the image horizontally on the
screen.
5. To center the image vertically, lift the front edge of the projector and press
the buttons on the sides of the projector, just above the feet, to release the
one-touch tilt feet.
6. To fine tune the image's position vertically on the screen, rotate each front
foot. (There is approximately 7° of up and down adjustment for the front of
the projector.)
7. Increase or reduce the size of the projected image by pressing the "Zoom"
and (+) or (-) buttons on the remote control.
INSTALLATION
Projection Distance and Image Size
350
300
250
200
150
100
50
0
6.56
13.12
19.69
0.0
(2.0)
(4.0)
(6.0)
Projection distance
39
WIDE
2
TELE
26.25
32.81
39.37
ft.
(8.0)
(10.0)
(12.0)
(m)
24
Advertisement
Table of Contents
