Table of Contents
Advertisement
T A B L E
O F
1. Introduction
Introduction To The MultiSync MT600 LCD Projector ...................................................... 13
Getting To Know Your MultiSync MT600 LCD Projector .................................................. 16
Front Features ............................................................................................................... 16
Rear Features ................................................................................................................ 16
2. Installation
Selecting A Location ..................................................................................................... 23
Rear Screen Projection .................................................................................................. 26
Connecting Your IR Receiver .............................................................................................. 32
Problem
Image is scrolling
vertically,
horizontally or both
Remote control
does not work
Status indicator is lit
or blinking
Cross color in
RGB mode
To Contact Your NEC Service Representative, Call 1-800-836-0655
C O N T E N T S
Check These Items
Use icons to select the source you
want to input.
Install new batteries. (See page 44.)
Make sure there are no obstacles between
you and the projector.
Make sure you are within 23 feet (7m)
of the projector.
See the Status Light message charton page 49.
If "Auto Picture" is off, turn it on. If "Auto
Picture" is on, turn it off and balance the image
with the Picture Adjustment icon and Fine
Picture Adjustment icon.
11
52
TROUBLESHOOTING
Advertisement
Table of Contents
