To Change Power Supply Cable - Ariston Margherita 2000 Instructions For Installation And Operation Manual

M
ARGHERITA
2000
Your safety and that of
your family
Read these instructions and all
the information in this manual
carefully: they are
important source, not only of
numerous useful tips, but also
of vital information on safety,
use and maintenance.
1. Margherita 2000 should
not be installed in an
outdoor environment,
not even when a roof
shelters the area, because
it may be very dangerous
to leave it exposed to rain
and thunderstorms.
2. It must only be used by
adults and exclusively for
washing clothes following
the instructions provided in
this manual.
3. Should it have to be moved,
proceed with the help of
two or three people and
handle it with the utmost
care. Never try to do this
alone, because
appliance is very heavy.
4. Before loading the washing
machine, make sure the
drum is empty.
How to change the power supply cable
(For this operation we suggest you contact a qualified engineer)
The Margherita 2000
power supply cable is
special and can
purchased exclusively
from authorised Tech-
nical Service Centres.
To replace the cable:
1. Make sure that Mar-
gherita 2000 is switched
off and unplugged.
I
Fig. 1
13
Margherita 2000 - Instructions for installation and use
Important for the safe use of your Margherita 2000
5. Never touch the washing
machine when barefoot
an or with wet or damp
hands or feet.
6. Never use extensions or
multiple plugs, which are
particularly dangerous in
humid environments. The
power supply cable must
never be bent
dangerously compressed.
I only want an
authorised specialised
technician with original
Ariston spare parts!
the
2. Remove the covering lid
by unscrewing the two
be screws I, and then pull it
towards you [fig. 1].
3. Disconnect the wires
from the radio interference
suppressor F [fig. 2] noting
as to their position (Blue=N
wire; Brown=L
leaving the earth wire until
last .
N
F
Margherita 2000 has been built in compliance
with the strictest international safety
regulations. To protect you and all your
family.
7. Never open the detergent
dispenser while the
appliance is functioning;
do not use hand wash
detergent because the
abundance of foam could
damage its internal parts.
or
N.B.: letters L, N and the
symbol are indicated on
the radio
suppressor.
4. Remove the upper part
of the cable slightly from
the back panel of the
appliance, pull the power
wire)
supply cable upwards and
take it out [fig. 3].
L
Fig. 2
8. Never pull on the supply
cable or the washing
machine to disconnect it
from the wall socket: it is
extremely dangerous.
9. While the appliance is
functioning, do not touch
the drain water as it
could reach very high
temperatures.
appliance door, during
wash cycles, tends to
become hot; ensure that
children do no touch it.
Never force the washing
machine door because
this could damage the
safety lock which prevents
accidental opening when
the nachine is working.
Allow a few minutes at the
end of the program for the
lock to release.
10. In case of malfunctio-
ning, first close the
water tap and unplug the
appliance from the wall
socket; do not under any
circumstances
internal parts in order to
attempt repairs.
To connect the new power
supply cable, reverse the
interference procedure.
To put the covering lid back
on, rest it on the washing
machine [fig. 4] and let it
slide forwards until the
hooks situated on the front
slide into the special slots
formed into the control
panel and
screws back on.
Fig. 3
The
touch
tighten the
Fig. 4