Makita GA5010 Instruction Manual page 8

To start the tool, depress the lock-off button and pull the
switch trigger. Release the switch trigger to stop.
For tool with typeB switch trigger
A
B
008415
For tool with the lock-on switch
To start the tool, simply pull the switch trigger (A).
Release the switch trigger to stop. For continuous
operation, pull the switch trigger (A) and then push in the
lock lever (B). To stop the tool from the locked position,
pull the switch trigger (A) fully, then release it.
For tool with the lock-off switch
To prevent the switch trigger from accidentally pulled, a
lock lever is provided. To start the tool, push in the lock
lever (B) and then pull the switch trigger (A). Release the
switch trigger to stop.
For tool with the lock on and lock-off switch
To prevent the switch trigger from accidentally pulled, a
lock lever is provided. To start the tool, push in the lock
lever (B) and then pull the switch trigger (A). Release the
switch trigger to stop. For continuous operation, push in
the lock lever (B), pull the switch trigger and then push
the lock lever further in (B). To stop the tool from the
locked position, pull the switch trigger (A) fully, then
release it.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Installing side grip (handle)
CAUTION:
Always be sure that the side grip is installed
•
securely before operation.
007993
1. Lock lever
2. Switch trigger
2
1
Screw the side grip securely on the position of the tool as
shown in the figure.
Installing loop handle (Accessory)
CAUTION:
Always be sure that the loop handle is installed
•
securely before operation.
1
008049
Always install the loop handle on the tool before
operation. Hold the tool's switch handle and the loop
handle firmly with both hands during operation.
Install the loop handle so that its protrusion will fit into the
matching hole in the gear housing.
Install the bolts and tighten them with the hex wrench.
The loop handle can be installed in two different
directions as shown in the figures whichever is
convenient for your work.
1
2
008047
1
3
008048
8
1. Protrusion of
loop handle
2. Matching hole in
gear housing
2
1. Loop handle
2. Hex wrench
3. Bolt
3
1. Loop handle
2. Hex wrench
3. Bolt
2