PEKOE
®
SINGLE CONTROL PULL-DOWN
KITCHEN FAUCET
SINGLE CONTROL PULL-DOWN
BAR FAUCET
Thank you for selecting American-Standard...the benchmark
of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--please
read these instructions carefully before you begin.
Recommended Tools
Phillips Screwdriver
1
INSTALL FITTING
Turn off hot and cold water
CAUTION
supplies before beginning.
Make certain the O-RING SEAL (1) is properly seated
in recess of faucet body.
Insert supply HOSES (2), SHANK (3) and SPRAY
HOSE (4) through center hole of sink or mounting
surface.
Assemble RUBBER WASHER (5), PLASTIC WASHER (6),
RUBBER & METAL "C" WASHERS (7) and long LOCKNUT (8)
onto SHANK (3) from underside of sink. Hand tighten
LOCKNUT (8) and check that faucet is centered.
Tighten LOCKNUT (8) with WRENCH (12) supplied. Insert
screwdriver into hole in WRENCH (12) and tighten.
Feed HOSE END (9) through HOSE GUIDE (10). Slide other
side of HOSE GUIDE (10) onto SHANK (3) and secure with
LOCK NUT (11). Do not over tighten!
Channel Locks
Installation
Instructions
4332.310
4332.310F15
4332.410
4332.410F15
Adjustable Wrench
Certified to comply with ANSI A112.18.1M
Plumbers' Putty or Caulking
RECESS
4
5
6
7
10
9
2
12
M 9 6 8 5 17 R E V. 1. 5
Tubing Cutter
1
3
8
11
SCREWDRIVER