Download Print this page

Polaris Vegas Owner's Manual: Headlight Aim Inspection

Victory motorcycles 2010 owner’s manual.
Hide thumbs

Advertisement

Maintenance

Headlight Aim Inspection

Bullet Headlights: The top edge of the high beam must be 3 inches (7.6
cm) below the height of the headlight housing parting line and centered
straight ahead at 25 feet (7.6 m).
Round Headlights: The top edge of the low beam must be at the same
height as the center of the headlight lens and centered straight ahead at
25 feet (7.6 m).
1. Verify that tire pressure is at specification. See page 110.
2. Verify that rear suspension ride height (preload) is at specification.
Include rider, passenger (if applicable) and cargo when setting
preload. See page 88.
3. Position the motorcycle on a level surface with the headlight 25 feet
(7.6 m) from a wall.
4. With the operator and passenger (if applicable) on board, bring the
motorcycle to the fully upright position.
5. Move the ignition switch to the ON position and switch the
headlamp to high beam. Observe the headlight aim on the wall.
6. Make any necessary adjustments to headlight aim.
120
Bullet Headlight High Beam
25 ft. (7.6 m)
3 in. (7.6 cm)
Height of headlamp
housing parting line
Round Headlight Low Beam
25 ft. (7.6 m)
Height of center
of headlamp lens

Advertisement

Chapters

   Related Manuals for Polaris Vegas

This manual also for:

Kingpin, Kingpin 8-ball

Comments to this Manuals

Symbols: 0
Latest comments: