Selecting The Reference Program - Beko Dishwasher Instruction Manual

and program cancellation will not be
possible.
Starting Your Machine
•
Open the tap.
•
Plug the mains plug into the wall
socket.
•
Open the door.
•
Press On/Off button.
•
Check if the salt and rinse aid
indicators light and add salt and/or
rinse aid if needed.
•
Place the dishes.
•
Check if the upper and lower
impellers rotate freely.
•
Put sufficient amount of detergent
in the detergent dispenser and
close its lid.
•
Start the program by pressing
Start/Pause/Cancel button.
WARNING:
Pay attention not to open the door of
the machine when it is running. Stop
the machine by pressing Start/Pause/
Cancel button if you have to open the
door. Then, open the door. There may
be a rush of vapor when you open
the door of your machine. Be careful.
Close the door and press Start/Pause/
Cancel button again. Program will
resume running.
•
Key lock will be activated 30
seconds after the program starts
and "Key Lock Activated" will be
displayed.
•
Energy saving system will be
activated 90 seconds after the
program starts and the display is
dimmed. If you touch the button
again, display brightness returns
to its original status.
•
"End" will be displayed when the
program is over. The amount of
water and energy consumed will
be displayed consecutively.
•
Press the On/Off button to turn off
your machine when the program is
over.
•
Close the tap.
•
Unplug the mains plug from the
wall socket.
•
Leave your dishes in the machine
for about 15 minutes after they
are washed in order to have them
cooled down. Your dishes will dry
in a shorter time if you leave the
door of your machine ajar during
this period. This will increase
the drying effectiveness of your
machine.
Selecting the Reference
Program
•
Press the On/Off button to turn
on your machine when its door is
open. Then, press the Start/Stop
button for 10 secs.
•
"Settings" will be displayed and
countdown will start from 10 secs.
•
You will enter in the "Settings"
menu at the end of the countdown
and the language selection menu
"Language" will be displayed.
•
"Ref. Program" will be displayed
when you press the Start/Stop
button once.
•
Press and hold the Start/Stop
button for 5 secs to enter the
reference program menu.
•
Press the Start/Stop button to
display ON or OFF options.
•
Press and hold the Start/Stop
button for 5 secs to save your
selection. "Saved" will be
displayed.
•
Turn off the machine by pressing
the On/Off button to exit the menu.
22 GB