Advertisement
DEFROSTING
The
Bottle
Cooler
has
automatic defrost system that
requires no special operations on
the part of the user. The on / off
cooling cycles of the appliance
are specifically designed to allow
for
defrost
during
normal
operation.
Note:- Clean and dry thoroughly
before switching
"ON" (as in
"Cleaning your Appliance")
INTERNAL LIGHT
The
coolers
are
fitted
with
internal fluorescent lights that
can be switched on and off using
the switch located at the bottom
of the cabinet. The light should
be turned off whenever it is not
required, in order to save energy.
Should
the
light
bulb
need
replacing first turn off the power
supply and remove the plug from
the socket.
The light cover is made from
flexible
polycarbonate.
remove it, starting at one end,
gently free it from the bottom
flange towards the rear of the
cabinet
and
then
pull
downwards.
The starter for the light is located
to the left of the light bulb and if
necessary may be removed by
giving it a ¼ turn and pulling it
from its socket.
The light bulb is rotated ¼ turn to
an
align the connector pins and then
moved carefully to free it from its
sockets. Replace the bulb with an
equivalent 8Watt or 15Watt (or in
some cases 4W) bulb and rotate it
¼ turn to lock it in position.
Locate the cover into the recess
of the light housing and feed its'
edge into place in the bottom
flange.
Plug in and restart the appliance.
To
it
5
CLEANING YOUR APPLIANCE
Your appliance is easy to keep
clean.
Regular
cleaning
important for health reasons.
Exterior:
Use a good wax polish that will
clean and polish the cabinet in
one easy application. DO NOT use
an aerosol polish as the spray
may damage plastic parts.
Interior:
Before using for the first time,
and when required, the interior of
your appliance should be wiped
with a soft cloth dampened with a
solution of one teaspoonful of
Bicarbonate of soda to one litre
of warm water. Rinse with clean
warm water, and dry thoroughly.
DO NOT use soaps, wire wool,
scouring powder or disinfectants
of any kind.
Periodically clean the gasket to
prevent a build up of beer and
sugar liquids.
USEFUL HINTS
If your appliance is to be out of
service for any length of time
ensure
that
the
interior
thoroughly cleaned and dried.
Leave
the
door
open
and
disconnect the plug from the
mains supply.
Carry out cleaning according to
instructions.
See that vibration noises are not
caused by the cabinet being on
an uneven surface. Adjust the
is
levelling foot.
SAFETY NOTES
If you are disposing of an old
cabinet, break off any latches and
remove doors, dispose of the
doors separately and safely.
DO ensure that the appliance is
earthed
DO ensure that the appliance is
disconnected
from
the
supply
before
attempting
remove the light cover.
DO
NOT
store
flammable
explosive
substances
cabinet.
Should the mains lead to this
appliance be changed for any
reason, it must be replaced by a
special lead (Part No. E 2622)
obtained from the address on the
back page of the instructions.
is
6
mains
to
or
in
the
Advertisement
