Related Manuals for Teac iTB500iP i-TALLBOY
Summary of Contents for Teac iTB500iP i-TALLBOY
- Page 1 Made for iPod iPhone TEAC CUSTOMER SUPPORT HOTLINE (TCS) 1300 553 315 Between Monday to Friday – AEST 8.30AM to 6PM...
- Page 2 SPECIFICATION Input voltage: ~220-240V/50Hz Power consumption: L/R speaker power and impedance: 2×15W /4 Ohm Subwoofer power and impedance: 30W / 6 Ohm Tuner frequency range: FM 87.50 - 108.00MHz IPod - iPod/iPhone dock Inputs: SD - SD memory card slot （Maximum capacity: 16GB) File format: Mp3, WMA, ASF.
-
Page 3: Trouble Shooting
Authorised Service Centre for repair. In this event, proof of purchase is required to support a warranty claim. After the repair, the product will be available for collection by or return to the purchaser at a fee upon request. TEAC in- Turn your unit off, then back on again. - Page 4 Keep your purchase receipt to enable you to proceed quickly in the event of a Warranty Service. If you require Warranty Service, please contact the TEAC Customer Support Hotline at 1300 553 315 for assistance. Please ensure that you have the model number, serial number and purchase receipt ready when you call.
-
Page 5: Table Of Contents
FOREWORD RADIO OPERATION 1. Enter FM Function THANKS Press the FM button on the remote control to enter FM mode. Dear Customer, 2. Select Bands We would like to take this opportunity to thank you for purchasing this unit. 1) Directly input frequency: press the F button on the remote control, then input the We strongly recommend that you carefully study the User Manual before attempting frequency that you want. -
Page 6: Warning
WARNING BASIC OPERATION Note: 1. If you do not touch any buttons for 5 seconds, the unit will exit to the station selection Please read and understand all the following warnings and those marked on the unit. screen. This unit has been designed and manufactured to assure personal safety. 2. -
Page 7: Accessories
BASIC OPERATION ACCESSORIES MENU BUTTON While playing the iPod, press the MENU button to return to the main menu status. iPod, AUDIO, FM BUTTONS USER MANUAL 1) Connect the iPod with this unit, then press iPod button on the remote control to enter the iPod mode. -
Page 8: Base Plate Installation
BASIC OPERATION BASE PLATE INSTALLATION PREPARATION (INSTALLATION SKETCH MAP) (DESIGN SKETCH) 1) Before the unit is turned on, please check if all the connections are correct. Then connect the mains power. 2) Switch the POWER ON/OFF button on the rear to turn on the unit. If the unit has connected with iPod or iPhone, it will enter to iPod status at the beginning, otherwise it will default to FM status. -
Page 9: Panels
PANELS VIDEO CONNECTION 1) Composite Video Output: In iPod mode, while playing the video files, connect the blue jack on rear panel of the unit to the video input jack of TV-set. (Note: the default of this unit is composite video output.) 1. -
Page 10: Remote Control
REMOTE CONTROL SYSTEM CONNECTION Before connecting acoustic equipment, pay attention to the picture below. NOTE: Each connection must be safe and firm. Disconnect power cable until you have 1. Aim the remote control directly at the remote control sensor of the unit. finished all the connections.