Drive installation guidelines
When adding drives to the server, observe the following general guidelines:
•
The system automatically sets all device numbers.
•
Populate drive bays, based on the drive numbering sequence. Start from the drive bay with the lowest
device number
•
When drives are grouped together into the same drive array, they must be of the same capacity to
provide the greatest storage space efficiency.
Installing a non-hot-plug drive
CAUTION:
all bays are populated with either a component or a blank.
To install the component:
Power down the server (on page 16).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Remove the drive carrier.
3.
Remove the two metal brackets from the drive carrier.
4.
("Drive
numbering" on page 12).
To prevent improper cooling and thermal damage, do not operate the server unless
Hardware options installation 32