Table of Contents
Advertisement
Quick Links
Push the HEPA filter cover button,open the
cover and take out the HEPA filter for cleaning
or replacement.Re-installing the HEPA filter
is the reverse of the removal process.Be sure
to close the HEPA cover and make sure it is
sealed securely.
Caution:the HEPA filter need to be cleaned or
replaced at least once a year.
4.trouble shooting
Cause
Problem
1.The plug is not entirely plugged
Motor will
into the socket or the socket does
not start
not have electricity.
2.The switch is in the OFF position.
1.The dust bag is full.
2.The filter, hose,brush etc, is
blocked.
Suction is low
If the trouble still exists, please contact our maintenance service department.
5. Technical Specification
Voltage
120V~
60Hz
Frequency
Power Input
Protection Class
R
7
Solution
1.Re-insert the plug into the socket
or try another socket.
2.Turn on the power switch.
1.Replace a new dust bag.
2.Clean the filter,hose,brush etc.
Max Vacuum
Noise
1200W
Class II
Division of B.V.C. Smyrna,GA 30082
R
Please read manual carefully and keep
future reference.
DCC-2HD
Instruction Manual
for
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Dust Care DCC-2HD
Summary of Contents for Dust Care DCC-2HD
-
Page 1: Instruction Manual
Push the HEPA filter cover button,open the DCC-2HD cover and take out the HEPA filter for cleaning or replacement.Re-installing the HEPA filter is the reverse of the removal process.Be sure Instruction Manual to close the HEPA cover and make sure it is sealed securely. - Page 2 When replacing the filter bag,open the dust Welcome to use our vacuum cleaner. You should read the manual before operation to make sure safety. Please keep the manual properly for cover and remove the bag.Replace the bag reference later. with an original factory supplied filter bag and close the cover.You may then continue cleaning.
- Page 3 GROUNDING INSTRUCTIONS This machine has a 3-Position switch.Press the switch backwards, and the vacuum will This appliance must be grounded. If it should malfunctionally breakdown, start to operate. Press the switch forward to grounding provides a path of least resistance for electric current to reduce turn on the vacuum and brush roll at the the risk of electric shock.
- Page 4 2. Part name and operation B.Operation guidance A. Part name Press the button on the hose cuff and take off the connector. Press the button of the dust cover as indicated in the left figure. Insert the dust bag into the bag housing.Make sure it is inserted correctly(see figure on left).
Need help?
Do you have a question about the DCC-2HD and is the answer not in the manual?
Questions and answers