Table of Contents
Advertisement
Powerboost function
The Powerboost function can be used to heat large amounts of
water more quickly than the power level
Restrictions when using
This function may be used for all hotplates, provided that the
other hotplate in the same group is not turned on. (See figure)
Otherwise, the
and
symbols will flash on the display of the
›
Š
selected hotplate; then the power level
without the function being activated.
*URXS
*URXS
Time programming function
This function may be used in two different ways:
to automatically switch off a hotplate.
■
as a timer.
■
Turning off a hotplate automatically
Enter the time period for the hotplate. The hotplate turns off
automatically once the time has elapsed.
How to program
Select the required hotplate and power level.
1.
Press the
symbol twice.
0
2.
function program display.
Program the time using symbols 1 to 9.
3.
The cooking time starts to count.
Once the time has elapsed
The hotplate switches off once this time has elapsed. A beep is
heard and
‹
.
‹
appears in the hotplate and the time
programming function display shows
When the
symbol is pressed, the displays turn off and the
0
beep goes off.
10
.
Š
is automatically set
Š
*URXS
*URXS
__ lights up on the time
‹‹ y
‹‹
for 10 seconds.
How to activate
Select a hotplate.
1.
Press the boost
symbol. The function has been turned on.
G
2.
To deactivate
Select a hotplate.
1.
Press the
boost symbol. The Powerboost function has
G
2.
been deactivated.
Note: In certain circumstances, the Powerboost function may
turn off automatically in order to protect the electronic
components inside the hob.
Changing or cancelling the time
Select the hotplate and press the
The __ and
r
displays appear
Change the cooking time using symbols 1 to 9 or press 0 to
cancel the time.
Notes
If a cooking time has been programmed, the display always
■
shows the time of this function. To check the cooking time
remaining in a hotplate, select a hotplate and press the
0
symbol twice.
If a time has been programmed for several hotplates, the
■
time of the selected hotplate is always shown.
Any cooking time can be programmed for up to 99 minutes.
■
Automatic timer
With this function you may select a cooking time for all
hotplates. Once a hotplate is switched on, the selected time will
begin to count down. The hotplate will automatically switch off
when the cooking time has elapsed.
Instructions on activating the timer are found in the chapter
entitled "Basic settings".
Note: The cooking time can be changed or cancelled for any
hotplate:
Press the
symbol several times until the
0
required hotplate lights up. Adjust the cooking time with
symbols 1 to 9 or deactivate with the symbol 0.
The timer
The timer can be set for periods of up to 99 minutes. It is
independent of the other settings. This function does not
automatically switch off a hotplate.
How to program
Press the
symbol. The indicator
0
1.
in the time program function display.
Set the required time using symbols 1 to 9.
2.
The time starts again after a few seconds.
symbol twice.
0
indicator of the
$
lights up.
lights up
U
‹‹
Advertisement
Table of Contents
