Table of Contents
Advertisement
2.0 Installation
Method 1 - Attaching the brackets to the front panel for rack mounting
Method 2 - Attaching the brackets to the sides of the unit for wall mounting
2.1 Unpacking
This product was carefully inspected before packing to ensure flawless appearance and operation.
Please unpack and inspect your CSM mixer for any damage that may have occurred during transit.
If damage is found, notify the transportation company immediately. Only you can initiate a claim for
shipping damage. We will be happy to help as needed. Save the shipping carton as evidence of damage
for the shipper's inspection.
We also recommend that you save all packing materials so you will have them if you ever need to
transport the unit.
2.2 Mechanical Requirements
We recommend leaving sufficient space around the sides, top, and rear of the mixer to ensure proper
ventilation. Forced cooling is not required. The mixer requires a vertical rack space of 1U. Failure to do
so may damage the mixer and invalidate the warranty.
2.3 Installing the Mixer
CAUTION: Before you begin, make sure that your mixer is disconnected from the power source and all
level controls are turned completely down (counter-clockwise).
To install the mixer, you can use one of the following approaches:
•
Install the mixer in a rack enclosure.
1.
Using the original brackets that came with the mixer, align the bracket's holes with the holes on the
mixer's chassis.
2.
Fasten the bracket with the provided screws.
3.
Follow steps 1 and 2 to install the remaining bracket(s) to the case, according to your application.
4.
Install the mixer into the cabinet. For further details about rack installation, refer to your cabinet's user
guide.
•
Install the mixer to the wall. See 'Method 2' in the above figure.
•
Stack mixer and amps without using a cabinet.
NOTE: WHEN TRANSPORTING, THE MIXER SHOULD BE SUPPORTED AT BOTH THE FRONT AND BACK.
6
Hide quick links:
Advertisement
Table of Contents
